Pinion Drive - Check
Show/hide table
| |
| Illustration 1 | g00716393 |
|
Pinion drive check (9) Pinion housing (10) Pinion | |
- Visually inspect the overrunning clutch of the pinion drive assembly for damage.
- Hold housing (9) and turn pinion (10) in the direction of operation. A clicking noise should be heard during this check.
- Hold housing (9) and turn pinion (10) in the opposite direction of operation. The pinion should not rotate.
- Hold housing (9) and press pinion (10) completely into the housing. Release the pinion. The pinion must spring back into the rest position.
- If any of the checks in Steps 1 through 4 are not correct, replace the pinion drive assembly.
Caterpillar Information System:
Starting Motor - Delco 50-MT Brush and Brush Holder - Check
345D, 349D and 349D2 Excavator Machine System Specifications Stick Cylinder Lines - Stick Lowering Control
Starting Motor - Delco 50-MT Armature - Test
Starting Motor - Delco 50-MT Field Winding - Test
Starting Motor - Delco 50-MT Starting Motor Solenoid - Test
Starting Motor - Delco 50-MT Pinion Continues to Engage after Engine Starts
Starting Motor - Delco 50-MT Starting Motor Continues to Operate after Start Switch Has Been Released
Starting Motor - Delco 50-MT Engine Does Not Crank with Starting Motor On and Pinion Engaging Ring Gear
Starting Motor - Delco 50-MT Pinion Does Not Engage Ring Gear
Starting Motor - Delco 50-MT Service Tools
Starting Motor - Delco 50-MT General Information
C9 On-highway Engine Cylinder Block Cover - Remove and Install
Starting Motor - Delco 50-MT No Load - Test
Starting Motor - Delco 50-MT Pinion Clearance - Adjust
Starting Motor - Delco 50-MT Starting Motor Does Not Turn or Turns Slowly
C9 Agricultural Engine for Challenger Tractors Engine Shutdown Is Intermittent
Starting Motor - Delco 50-MT General Information
Starting Motor - Delco 50-MT Starting Motor - Disassemble
Starting Motor - Delco 50-MT Starting Motor - Assemble
3176C, 3406E and 3456 Industrial Engines Engine Stalls at Low RPM
C4.4 (Mech) Industrial Engine Crankcase Breather (Canister) - Replace
C3.4 IND Industrial Engine Engine Valve Lash - Inspect/Adjust
C4.4 and C6.6 Engines for Caterpillar Built Machines Fuel Rail Pump Solenoid - Test
C3.4 IND Industrial Engine Reference Material