Starting the Engine
Show/hide table
不要使用类似乙醚的喷雾式起动辅助装置。 否则可能导致爆炸和人身伤害。 |
请参阅针对您的具体操控类型的维修手册。 使用下述程序来起动发动机。
- 起动发动机前,将油门操纵杆移到低怠速位置。
注: 如有必要,增大油门位置以便发动机在低温条件下起动。 发动机转速不得超过 1500 转/分钟,直到机油压力增加。
Show/hide table注意 使用预热塞一次不要超过 60 秒钟。 预热塞有可能被损坏。
Show/hide table图 1 g06038854 - 将发动机起动开关转到加热位置。 将发动机起动开关保持在加热位置,时间如图 1 所示。 此动作将启用预热塞,帮助发动机进行起动。
Show/hide table
注意 发动机盘车时间不要超过30秒钟。 再次盘车前,让起动马达先冷却2分钟。
- 预热塞指示灯点亮的同时,将发动机起动开关转到起动位置,拖动发动机。
- 当发动机起动时,松开发动机起动开关。
- 将油门操纵杆缓慢移到低怠速位置,让发动机怠速运转。 请参阅操作和保养手册, "起动发动机后"主题。
注: 如果预热塞指示灯闪烁 2 到 3 秒或未点亮,冷起动系统存在故障。 不要使用乙醚或其它起动液体来起动发动机。
- 如果发动机没有起动,松开发动机起动开关,使电动起动马达冷却。 然后,重复步骤 2 至步骤 5。
- 将发动机起动开关转至断开位置,停止发动机。
Caterpillar Information System:
C9 Engine for the 816F Series 2 Landfill Compactor, the 815F Series 2 Soil Compactor, and the 814F Series 2 Wheel Dozer Speed/Timing - Test
Exhaust Temperature Module Communication - SAE J1939 CAN Data Link and RS-485 Data Link
Test Specifications for Vane Cartridges{0784, 5058, 5070} Test Specifications for Vane Cartridges{0784, 5058, 5070}
2007/02/05 A Conversion Kit for the Status Control Panel is Available {1408}
C11 and C13 Engines Turbocharger
C27 and C32 Generator Set Engines Vibration Damper and Pulley
G3508B, G3512B, G3512B, G3516B and G3520B Petroleum Engines Exhaust Manifold - Install
3500C Marine Auxiliary Engines Engine Control Switch - Test
3500C Marine Auxiliary Engines Sensor Signal (Analog, Active) - Test
3500B Industrial Engines Maintenance Recommendations
2007/05/14 New Circuit Breakers Are Now Available {1420}
G3508B, G3512B, G3512B, G3516B and G3520B Petroleum Engines Exhaust Manifold - Remove
TH55FT-E70 and TH55FT-E90 Petroleum Transmissions Power Train Hydraulic System
TH55FT-E70 and TH55FT-E90 Petroleum Transmissions Torque Converter
C4.4 (Mech) Industrial Engine Piston Cooling Jet
3500C Marine Auxiliary Engines Injector Solenoid - Test
3500C Marine Auxiliary Engines Prelubrication - Test
2008/02/11 The Heavy Pistons are Cancelled {1214, 1225}
2013/02/27 New Fuel Pressure Regulators are Now Available {1715}
2007/02/05 New Fuel Pressure Regulators are Now Available {1715}
2007/02/01 New Fuel Pressure Regulators are Now Available {1715}
3500B Industrial Engines Instrument Panel
C6.6 Industrial Engine Maintenance Interval Schedule
2007/01/01 Make Sure that the Oil Shields are Installed Correctly {1100}