Installation Procedure
Show/hide table
Table 1
Required Tools     |
Tool     |
Part Number     |
Part Description     |
Qty     |
A     |
8T-5255     |
Hydraulic Jack     |
1     |
B     |
138-7574     |
Link Bracket     |
3     |
C     |
1U-9200     |
Lever Puller Hoist     |
1     |
Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.
Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Show/hide table
|
NOTICE |
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
|
Show/hide table
|
|
|
Illustration 1 | g01306593 |
- Attach Tooling (B), Tooling (C), and a suitable lifting device to pump mounting (16). The weight of pump mounting (16) is approximately 318 kg (700 lb).
Show/hide table
|
|
|
Illustration 2 | g01306594 |
- Position pump mounting (16). Install bolts (17) and (18).
Show/hide table
|
|
|
Illustration 3 | g01304015 |
- Remove Tooling (A) from flywheel housing (15) .
Show/hide table
|
|
|
Illustration 4 | g01306696 |
- Install plate assembly (14) .
Show/hide table
|
|
|
Illustration 5 | g01304014 |
- Connect hose assembly (13) and install bolt (12) .
Show/hide table
|
|
|
Illustration 6 | g01304012 |
- Position bracket assembly (10) and install bolts (11) .
Show/hide table
|
|
|
Illustration 7 | g01303722 |
- Connect harness assemblies (9) .
Show/hide table
|
|
|
Illustration 8 | g01306592 |
Show/hide table
|
|
|
Illustration 9 | g01303721 |
- Connect hose assemblies (8). Connect tube assemblies (5) and hose assemblies (6) to manifold (7).
Show/hide table
|
|
|
Illustration 10 | g01303720 |
- Connect hose assemblies (3) and hoses (4) .
Show/hide table
|
|
|
Illustration 11 | g01303717 |
- Connect hose assemblies (1) and (2) .
End By:
Install the implement pump. Refer to Disassembly and Assembly, "Implement Pump - Install".