An Updated Gasket for the Water Temperature Regulator Housing is Available {1355, 1380, 1393}
- Caterpillar Products:
- 3500 Family Generator Sets and Power Modules
- 3500 Family Pumpers
- G3500 Family Generator Sets and Power Modules
- Engine: Commercial
- 3500 and 3500B Family All
- G3500 Family All
Show/hide table
Illustration 1 | g01304235 |
Typical eample of the gasket |
An updated 7E-6016 Gasket is now available. The updated gasket improves the sealing effectiveness of the connection for the outlet of the water temperature regulator housing on 3500 and G3500 Engines. The updated gasket includes the addition of four sealing beads on one side of the gasket surface between the bolt holes.
Note: The orientation of the bead within the connection is not important. Do not use of any joint compound or sealing compound with this connection.
Ensure that the mating surfaces of the connection are clean, flat and dry.
Existing dealer inventory of the previous revision of this gasket may be exhausted normally.
Caterpillar Information System:
C11 and C13 Engines and 14M and 16M Motor Graders Sensor Signal (Analog, Active) - Test
G3520C and G3520E Generator Set Engines Control Module - Replace
G3520C and G3520E Generator Set Engines Electrical Connectors - Inspect
G3520C and G3520E Generator Set Engines ECM - Replace
G3600 Engines Prechamber - Clean/Inspect
G3520C and G3520E Generator Set Engines Starting - Test
G3520C and G3520E Generator Set Engines Speed/Timing - Test
C13 On-highway Engine Clean Gas Induction Valve
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Crankshaft Front Seal - Remove and Install
C0.5, C0.7, C1.1, C1.5, C1.6 and and C2.2 Industrial Engines Crankshaft Rear Seal - Remove and Install
C0.5, C0.7, C1.1, C1.5, C1.6 and and C2.2 Industrial Engines Fuel Injection Pump - Remove and Install
G3520C and G3520E Generator Set Engines Throttle Actuator - Test
C13 On-highway Engine Exhaust Extension
G3600 Engines ECM Software - Install
C13 On-highway Engine Exhaust Extension
G3520C and G3520E Generator Set Engines Timing - Calibrate
G3520C and G3520E Generator Set Engines Generator Output Power Sensor - Set
G3520C and G3520E Generator Set Engines Speed Control (Switch) - Test
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission Does Not Automatically Shift Into Neutral
G3520C and G3520E Generator Set Engines Indicator Lamp - Test
C11 and C13 Engines and 14M and 16M Motor Graders Sensor Supply - Test
G3304B and G3306B Engines Valve Lash Is Excessive
C15 On-Highway Engine Engine Oil Pan
C11 and C13 Engines and 14M and 16M Motor Graders Shutdown (Ground Level) - Test