248-3919 Track Roller Frame Gp
Illustration 1 | g01670093 |
Left side view |
(1) After assembly of the idler, fill the grease fitting with 3E-6694 Lubricant.
(2) Installation torque for the relief valve ... 35 ± 5 N·m (26 ± 4 lb ft)
(3) Torque for the fill valve ... 35 ± 5 N·m (26 ± 4 lb ft)
(4) Torque for the bolt ... 300 N·m (220 lb ft)
(5) Tighten the four bolts first during assembly of the track adjuster and recoil group.
(6) 239-8240 Spring
- Length under test force ... 500 mm (19.7 inch)
- Test force ... 133000 ± 6000 N (29900 ± 1350 lb)
- Free length after test ... 616 mm (24.3 inch)
- Outside diameter ... 190.0 ± 2.0 mm (7.48 ± 0.08 inch)
- Test force ... 133000 ± 6000 N (29900 ± 1350 lb)
(7) During the assembly of the seven track rollers, make sure that the lube hole on the center shaft faces the outside of the tractor.
Illustration 2 | g01670233 |
Section A-A |
(8) Two sleeve bearings must be flush with the surface.
(B) Diameter of the sleeve bearing after assembly ... 69.856 ± 0.134 mm (2.7502 ± 0.0053 inch)
(C) Diameter of the sleeve bearing after assembly ... 88.744 ± 0.084 mm (3.4938 ± 0.0033 inch)
314-5992 Track Roller Frame Gp
Illustration 3 | g01672994 |
Left side view |
(1) After assembly of the idler, fill the grease fitting with 3E-6694 Lubricant.
(2) Installation torque for the relief valve ... 35 ± 5 N·m (26 ± 4 lb ft)
(3) Torque for the fill valve ... 35 ± 5 N·m (26 ± 4 lb ft)
(4) Torque for the bolt ... 300 N·m (220 lb ft)
(5) Tighten the four bolts first during assembly of the track adjuster and recoil group.
(6) 239-8240 Spring
- Length under test force ... 500 mm (19.7 inch)
- Test force ... 133000 ± 6000 N (29900 ± 1350 lb)
- Free length after test ... 616 mm (24.3 inch)
- Outside diameter ... 190.0 ± 2.0 mm (7.48 ± 0.08 inch)
- Test force ... 133000 ± 6000 N (29900 ± 1350 lb)
(7) During the assembly of the seven track rollers, make sure that the lube hole on the center shaft faces the outside of the tractor.
Illustration 4 | g01670233 |
Section A-A |
(8) Two sleeve bearings must be flush with the surface.
(B) Diameter of the sleeve bearing after assembly ... 69.856 ± 0.134 mm (2.7502 ± 0.0053 inch)
(C) Diameter of the sleeve bearing after assembly ... 88.744 ± 0.084 mm (3.4938 ± 0.0033 inch)