Clean Gas Induction Valve - Assemble
Assembly Procedure
Note: This component is being disassembled and displayed for CLEANING PURPOSES ONLY. Many internal parts are not available for this component. Care must be taken during disassembly and assembly in order to prevent damage to unavailable parts.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Check O-ring seal (13) for wear or for damage. If necessary, replace O-ring seal (13) .
Show/hide table
Illustration 1 | g01265789 |
Typical Example |
- Install housing (11). Install bolts (10). If wiper (12) is worn or damaged replace the clean gas induction valve. Install O-ring seal (9) .
Show/hide table
Illustration 2 | g01265787 |
Typical Example |
- Install O-ring seals (8) onto valve (7). Install valve (7). Tighten valve (7) to a torque of 50 ± 5 N·m (37 ± 4 lb ft). Install coil assembly (6) and nut (5). Tighten nut (5) to a torque of 20 ± 3 N·m (15 ± 2 lb ft).
Show/hide table
Illustration 3 | g01265786 |
- Install cover (2) onto clean gas induction valve (3). Install bolts (1) .
Show/hide table
Illustration 4 | g01301878 |
End By: Install the clean gas induction valve. Refer to Disassembly and Assembly, "Clean Gas Induction Valve - Install".
Caterpillar Information System:
G3600 Engines Engine Operation
C13 Engine Clean Gas Induction Valve - Disassemble
C13 Engine Inlet and Exhaust Valve Guides - Remove and Install
C13 Engine Cylinder Liner - Remove
3512B Marine Auxiliary Engine Refill Capacities and Recommendations
C11 and C13 Engines and 14M and 16M Motor Graders Cat Data Link - Test
C9 Engines for Motor Graders Configuration Parameters
3512B Marine Auxiliary Engine Product Storage
C280-12 and C280–16 Marine Engines Camshaft - Remove
C15 and C18 Petrolem Generator Set Engines Wiring Information
C11 and C13 Engines and 14M and 16M Motor Graders Electrical Power Supply - Test
3612 and 3616 Engines Cylinder Liner - Install
C280-12 and C280–16 Marine Engines Camshaft - Install
G3520C and G3520E Engines Pressure Sensor
C175-16 Locomotive Engine Pressure Sensor
C13 Engines for Caterpillar Built Machines Engine Misfires, Runs Rough or Is Unstable
2006/12/25 A New Rear Frame Is Now Used on the Heat Exchanger for Marine Engines {1379}
G3600 Engines Alternator - Inspect
G3600 Engines Belts - Inspect/Adjust/Replace
G3520C and G3520E Generator Set Engines Engine Speed/Timing Sensor
G3520C and G3520E Generator Set Engines General Information
G3520C and G3520E Generator Set Engines Welding Precaution
G3520C and G3520E Generator Set Engines Diagnostic Capabilities
G3600 Engines Programmable Parameters