Clean Gas Induction Valve - Disassemble
Disassembly Procedure
Start By:
- Remove the clean gas induction valve. Refer to Disassembly and Assembly, "Clean Gas Induction Valve - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: This component is being disassembled and displayed for CLEANING PURPOSES ONLY. Many internal parts are not available for this component. Care must be taken during disassembly and assembly in order to prevent damage to unavailable parts.
- Remove bolts (1). Remove cover (2) from clean gas induction valve (3) .
Show/hide table
Illustration 1 | g01301878 |
- Remove nut (5), coil assembly (6), and valve (7). Remove O-ring seals (8) from cover (4) .
Show/hide table
Illustration 2 | g01265786 |
- Remove O-ring seal (9). Check wiper (12) for wear or damage. Remove bolts (10). Remove housing (11) .
Show/hide table
Illustration 3 | g01265787 |
Typical example |
- Check O-ring seal (13) for wear or for damage.
Show/hide table
Illustration 4 | g01265789 |
Typical example |
Caterpillar Information System:
C13 Engine Inlet and Exhaust Valve Guides - Remove and Install
C13 Engine Cylinder Liner - Remove
3512B Marine Auxiliary Engine Refill Capacities and Recommendations
C11 and C13 Engines and 14M and 16M Motor Graders Cat Data Link - Test
C9 Engines for Motor Graders Configuration Parameters
3512B Marine Auxiliary Engine Product Storage
C280-12 and C280–16 Marine Engines Camshaft - Remove
C15 and C18 Petrolem Generator Set Engines Wiring Information
C11 and C13 Engines and 14M and 16M Motor Graders Electrical Power Supply - Test
3612 and 3616 Engines Cylinder Liner - Install
C11 and C13 Engines and 14M and 16M Motor Graders Cooling Fan Control - Test
C11 and C13 Engines and 14M and 16M Motor Graders Electrical Connectors
G3600 Engines Engine Operation
C13 Engine Clean Gas Induction Valve - Assemble
C280-12 and C280–16 Marine Engines Camshaft - Install
G3520C and G3520E Engines Pressure Sensor
C175-16 Locomotive Engine Pressure Sensor
C13 Engines for Caterpillar Built Machines Engine Misfires, Runs Rough or Is Unstable
2006/12/25 A New Rear Frame Is Now Used on the Heat Exchanger for Marine Engines {1379}
G3600 Engines Alternator - Inspect
G3600 Engines Belts - Inspect/Adjust/Replace
G3520C and G3520E Generator Set Engines Engine Speed/Timing Sensor
G3520C and G3520E Generator Set Engines General Information
G3520C and G3520E Generator Set Engines Welding Precaution