Inlet and Exhaust Valve Guides - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 1U-9169 | Valve Guide Driver | 1 |
Start By:
- Remove the inlet valves and exhaust valves. Refer to Disassembly and Assembly, "Inlet and Exhaust Valves - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Use Tooling (A) to remove the valve guides from the cylinder head assembly.
Show/hide table
Illustration 1 | g01015291 |
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
B | 124-9057 | Guide Collar | 1 |
9U-6895 | Valve Guide Driver | 1 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Lubricate the bores for the valve guides with clean engine oil.
- Use Tooling (B) to install valve guides (1). Install the valve guides until the protrusion is Dimension (X) above the cylinder head assembly. Dimension (X) is
20.0 ± 0.5 mm (0.79 ± 0.02 inch) .
Show/hide table
Illustration 2 | g06127722 |
End By:
- Install the inlet valves and exhaust valves. Refer to Disassembly and Assembly, "Inlet and Exhaust Valves - Remove and Install".
Caterpillar Information System:
C13 Engine Cylinder Liner - Remove
3512B Marine Auxiliary Engine Refill Capacities and Recommendations
C11 and C13 Engines and 14M and 16M Motor Graders Cat Data Link - Test
C9 Engines for Motor Graders Configuration Parameters
3512B Marine Auxiliary Engine Product Storage
C280-12 and C280–16 Marine Engines Camshaft - Remove
C15 and C18 Petrolem Generator Set Engines Wiring Information
C11 and C13 Engines and 14M and 16M Motor Graders Electrical Power Supply - Test
3612 and 3616 Engines Cylinder Liner - Install
C11 and C13 Engines and 14M and 16M Motor Graders Cooling Fan Control - Test
C11 and C13 Engines and 14M and 16M Motor Graders Electrical Connectors
C11 and C13 Engines and 14M and 16M Motor Graders Component Location
C13 Engine Clean Gas Induction Valve - Disassemble
G3600 Engines Engine Operation
C13 Engine Clean Gas Induction Valve - Assemble
C280-12 and C280–16 Marine Engines Camshaft - Install
G3520C and G3520E Engines Pressure Sensor
C175-16 Locomotive Engine Pressure Sensor
C13 Engines for Caterpillar Built Machines Engine Misfires, Runs Rough or Is Unstable
2006/12/25 A New Rear Frame Is Now Used on the Heat Exchanger for Marine Engines {1379}
G3600 Engines Alternator - Inspect
G3600 Engines Belts - Inspect/Adjust/Replace
G3520C and G3520E Generator Set Engines Engine Speed/Timing Sensor
G3520C and G3520E Generator Set Engines General Information