Cylinder Liner - Remove
Removal Procedure
Show/hide table
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 5P-8665 | Cylinder Liner Puller Gp | 1 |
| B | 129-6675 | Cylinder Pack Puller | 1 |
| 1U-9897 | Bridge | 1 | |
| 1U-6319 | Socket | 1 | |
Start By:
- Remove the pistons and the connecting rods. Refer to Disassembly and Assembly, "Pistons and Connecting Rods - Remove".
- Use Tooling (A) to remove cylinder liner (1) .
Show/hide table
 | |
| Illustration 1 | g01005579 |
- Remove the O-ring seals from cylinder liner (1) .
Caterpillar Information System:
3512B Marine Auxiliary Engine Refill Capacities and Recommendations
C11 and C13 Engines and 14M and 16M Motor Graders Cat Data Link - Test
C9 Engines for Motor Graders Configuration Parameters
3512B Marine Auxiliary Engine Product Storage
C280-12 and C280–16 Marine Engines Camshaft - Remove
C15 and C18 Petrolem Generator Set Engines Wiring Information
C11 and C13 Engines and 14M and 16M Motor Graders Electrical Power Supply - Test
3612 and 3616 Engines Cylinder Liner - Install
C11 and C13 Engines and 14M and 16M Motor Graders Cooling Fan Control - Test
C11 and C13 Engines and 14M and 16M Motor Graders Electrical Connectors
C11 and C13 Engines and 14M and 16M Motor Graders Component Location
CX31 On-Highway Transmission Power Train Pump Drive - Install - Rear PTO shaft
C13 Engine Inlet and Exhaust Valve Guides - Remove and Install
C13 Engine Clean Gas Induction Valve - Disassemble
G3600 Engines Engine Operation
C13 Engine Clean Gas Induction Valve - Assemble
C280-12 and C280–16 Marine Engines Camshaft - Install
G3520C and G3520E Engines Pressure Sensor
C175-16 Locomotive Engine Pressure Sensor
C13 Engines for Caterpillar Built Machines Engine Misfires, Runs Rough or Is Unstable
2006/12/25 A New Rear Frame Is Now Used on the Heat Exchanger for Marine Engines {1379}
G3600 Engines Alternator - Inspect
G3600 Engines Belts - Inspect/Adjust/Replace
G3520C and G3520E Generator Set Engines Engine Speed/Timing Sensor