Product Storage
If the engine will not be started for several weeks, the lubricating oil will drain from the cylinder walls and from the piston rings. Rust can form on the cylinder walls, resulting in increased engine wear and reduced engine service life.
To help prevent excessive engine wear, use the following guidelines:
- Complete all of the lubrication recommendations that are listed in the Operation and Maintenance Manual, "Maintenance Interval Schedule" in the Maintenance Section.
- If freezing temperatures are expected, check the cooling system for adequate protection against freezing. Refer to the Operation and Maintenance Manual, "Refill Capacities and Recommendations" in the Maintenance Section for additional information.
Special precautions should be made under the following conditions:
- The engine is out of operation.
- Use of the engine is not planned.
If the engine will be stored for more than one month, a complete protection procedure is recommended. Consult your Caterpillar dealer. Your Caterpillar dealer will have instructions for preparing the engine for extended storage periods.
Refer to the Special Instruction, SEHS9031 for more detailed information on engine storage.
Caterpillar Information System:
C280-12 and C280–16 Marine Engines Camshaft - Remove
C15 and C18 Petrolem Generator Set Engines Wiring Information
C11 and C13 Engines and 14M and 16M Motor Graders Electrical Power Supply - Test
3612 and 3616 Engines Cylinder Liner - Install
C11 and C13 Engines and 14M and 16M Motor Graders Cooling Fan Control - Test
C11 and C13 Engines and 14M and 16M Motor Graders Electrical Connectors
C11 and C13 Engines and 14M and 16M Motor Graders Component Location
CX31 On-Highway Transmission Power Train Pump Drive - Install - Rear PTO shaft
CX28 On-Highway Transmission Operational Checks
C11 and C13 Engines and 14M and 16M Motor Graders System Overview
2006/10/02 Improved Instrument Panels are Used {7451}
C11 and C13 Engines and 14M and 16M Motor Graders Electronic Service Tool Does Not Communicate
C9 Engines for Motor Graders Configuration Parameters
C11 and C13 Engines and 14M and 16M Motor Graders Cat Data Link - Test
3512B Marine Auxiliary Engine Refill Capacities and Recommendations
C13 Engine Cylinder Liner - Remove
C13 Engine Inlet and Exhaust Valve Guides - Remove and Install
C13 Engine Clean Gas Induction Valve - Disassemble
G3600 Engines Engine Operation
C13 Engine Clean Gas Induction Valve - Assemble
C280-12 and C280–16 Marine Engines Camshaft - Install
G3520C and G3520E Engines Pressure Sensor
C175-16 Locomotive Engine Pressure Sensor
C13 Engines for Caterpillar Built Machines Engine Misfires, Runs Rough or Is Unstable