G3520C and G3520E Generator Set Engines Caterpillar


Engine Overspeeds

Usage:

G3520C B9P
使用本步骤诊断和排除发动机超速故障,或在下列任一事件代码为现行状态或被记录时使用本步骤。

表 1
事件代码    
说明     激活代码的条件     系统响应    
E004(3)发动机超速停机     发动机转速已经超过编程在电子控制模块(ECM)中的触发点。     停机输出被启动。 燃气切断阀断电。 点火被切断。 系统将会记录该代码。 发动机停机。    
E362(3)发动机超速    

注: 请参考故障诊断与排除, "发动机监控系统"以了解关于触发点和延迟时间的信息。

当按下紧急停机按钮时,点火立即被终止。 未燃烧的燃气留在进气和排气系统中。

------ WARNING! ------

当发动机被起动时,进排气系统里残存的燃气可能被点燃。 可能造成人身伤害和/或财产损失。

起动一台含未燃烧的燃气的发动机之前,从进排气系统清除这些未燃烧的燃气。 参阅"起动发动机"有关清除未燃烧燃气的章节。


可能原因

  • 发动机超速触发点低

  • 来自油门执行器的主电子控制模块(ECM)中的信号驱动器的信号

  • 从动设备的能量

  • 调速器响应慢

  • 油门执行器阻滞

修理建议

检查触发点

注: 不要将发动机超速的触发点编程为高于从动设备的最大额定值。

发动机超速触发点可能太低。 确认正确编程了发动机超速触发点。 通常情况下,该参数被设置在额定转速的 118%。

该参数需要出厂密码才能更改触发点。 如有必要,将触发点改变到可接受的转速。

检查有无与来自主 ECM 中的信号驱动器的信号有关的诊断代码

检查有无与油门执行器有关的诊断代码。

调查诊断代码。 进行必要的修理。

检查从动设备

确定从动设备是否带有可能会使发动机超出触发点的其他能量输入。 对设备进行改进,以便防止超速重现。

检查是否调速器响应慢

观察 Caterpillar 电子技师(ET)上的 "Speed Governor Adjustment"(调速器转速调整)屏幕。 查找有无发动机对最坏的分步加载和卸载状况的响应。

检查油门执行器有无阻滞

从发动机上拆下电源。 感到有运动时,移动油门盘。 如果这种运动是粘滞和/或粗暴的,则查明阻滞的原因。 进行必要的修理。

Caterpillar Information System:

G3520C and G3520E Generator Set Engines Oil Temperature Is High
TH48-E70 Oil/Gas Transmission and TH48-E70-C27 and TH48-E70-C32 Package Transmission Planetary - Assemble
TH48-E70 Oil/Gas Transmission and TH48-E70-C27 and TH48-E70-C32 Package Transmission Planetary - Disassemble
TH48-E70 Oil/Gas Transmission and TH48-E70-C27 and TH48-E70-C32 Package Transmission Planetary - Install
TH48-E70 Oil/Gas Transmission and TH48-E70-C27 and TH48-E70-C32 Package Transmission Planetary - Remove
G3520C and G3520E Generator Set Engines Coolant Temperature Is Low
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Front Screen and Air Filter
G3520C and G3520E Generator Set Engines Coolant Temperature Is High
C15 and C18 Petrolem Generator Set Engines Programmable Parameters
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Door
C15 and C18 Petrolem Generator Set Engines Diagnostic Capabilities
C15 and C18 Petrolem Generator Set Engines Welding Precaution
G3520C and G3520E Generator Set Engines Fuel Pressure Problem
G3520C and G3520E Generator Set Engines Inlet Air Temperature Is High
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Door Pull and Retaining Ring
G3520C and G3520E Generator Set Engines Coolant Pressure Is Low
C13 Engine Turbocharger - Remove - High Pressure
C13 Engine Turbocharger - Install - High Pressure
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Door Latch
G3520C and G3520E Generator Set Engines Coolant Pressure Is High
C13 Engine Turbocharger - Remove - Low Pressure
C13 Engine Turbocharger - Install - Low Pressure
G3520C and G3520E Generator Set Engines System Voltage Problem
C13 Engine Precooler - Remove
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.