D11R Starter Solenoid Connections{1467} Caterpillar


D11R Starter Solenoid Connections{1467}

Usage:

D11R 7PZ
Track-Type Tractor:
D11R (S/N: AAF1-UP; 7PZ1-UP)

Introduction

The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.

Problem




Illustration 1g01290408

The "B+" terminal on the front of the lower starter solenoid (1) may be loose or separated from the solenoid. The cause of this failure is currently under investigation.

Solution

In warm weather, a D11R may start with only one functional starter. It may not be apparent that one starter has a failed or loose connection.If inspection reveals a loose or separated terminal replace the solenoid with the current parts until a permanent solution is determined. This will avoid any dead shorts or arcing of electrical components that might result in damage to surrounding components.

Caterpillar Information System:

657G Wheel Scraper Power Train Final Drive and Wheel - Install
657G Wheel Scraper Power Train Final Drive and Wheel - Remove
D6K Track-Type Tractor Electrohydraulic Power Train Track Roller
657G Wheel Scraper Power Train Power Train Guard (Transmission) - Remove and Install
2006/07/31 Bearing Inserts Are Now Used in Frame Steering Bracket {7051, 7073}
Underground Articulated Trucks Truck Payload Measurement System Service Tools
D7G Series 2 and D7G Series II Track-Type Tractors Condenser (Refrigerant) - Clean
D7G Series 2 and D7G Series II Track-Type Tractors Emissions Certification Film
D7G Series 2 and D7G Series II Track-Type Tractors Fuel Tank Cap and Strainer - Clean
Installation Instructions for the 291-1184 Secondary Steering Group (Kit) {4300} Installation Instructions for the 291-1184 Secondary Steering Group (Kit) {4300}
657G Wheel Tractor-Scraper Wheel Tractor Power Train Power Train Guard (Transmission) - Remove and Install
953D Track-Type Loader Machine Systems Cab - Install
Load Haul Dump Machine Machining & Welding Information Consumables
Machining and Welding Information for Underground Articulated Trucks Rear Frame
Machining and Welding Information for Underground Articulated Trucks Front Frame
953D Track-Type Loader Machine Systems Lift Cylinder - Remove and Install
953D Track-Type Loader Machine Systems Piston Pump (Implement) - Remove
953D Track-Type Loader Machine Systems Piston Pump (Implement) - Install
953D Track-Type Loader Machine Systems Fan and Gear Motor (Hydraulic Fan) - Remove
D7G Series 2 and D7G Series II Track-Type Tractors Cutting Edges and End Bits - Inspect/Replace
D7G Series 2 and D7G Series II Track-Type Tractors Battery Disconnect Switch
657G Wheel Tractor-Scraper Machine Systems Steering Control Valve - Remove
D7G Series 2 and D7G Series II Track-Type Tractors Fuses and Circuit Breakers - Replace/Reset
953D Track-Type Loader Machine Systems Fan and Gear Motor (Hydraulic Fan) - Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.