Flywheel Housing - Remove and Install
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件描述 | 数量 |
A | 138-7575 | 连杆支架 | 2 |
B | - | 导向螺栓 M12 x 1.75 x 5 in |
2 |
开始:
- 拆下飞轮。 参考拆解和组装, "飞轮 - 拆卸和安装"。
- 拆下电起动马达。 请参阅拆解和组装, "电起动马达 - 拆卸和安装"。
- 拆下两个螺栓 (3)。 将工具 (B) 安装到缸体中。
- 将工具 (A) 和适当的起吊设备连接到飞轮壳 (1) 上。 飞轮壳 (1) 的重量约为
37 kg (82 lb) 。 - 拆下螺栓 (2)。 拆下剩余的螺栓 (3)。
- 拆下将发动机油底壳固定在飞轮壳 (1) 上的螺栓 (4) (图上未显示)。 拆下飞轮壳 (1)。
Show/hide table
图 1 | g01272224 |
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件描述 | 数量 |
A | 138-7575 | 连杆支架 | 2 |
B | - | 导向螺栓 M12 x 1.75 x 5 in |
2 |
C | 1U-8846 | 密封垫密封胶 | 1 |
- 安装之前先在飞轮壳整个安装面上涂敷工具 (C)。
Show/hide table
图 2 g01272224 - 将工具 (B) 安装到缸体中。
- 将工具 (A) 和适当的起吊设备连接到飞轮壳 (1) 上。 飞轮壳 (1) 的重量约为
37 kg (82 lb) 。 将飞轮壳 (1) 放置到工具 (B) 上。 - 安装螺栓 (2)。 安装螺栓 (3)。 拆下工具 (B),然后安装其余的螺栓 (3)。
- 安装将发动机油底壳固定在飞轮壳 (1) 上的螺栓 (4)(图上未显示)。
结束:
- 安装电起动马达。 请参阅拆解和组装, "电起动马达 - 拆卸和安装"。
- 安装飞轮。 参考拆解和组装, "飞轮 - 拆卸和安装"。
Caterpillar Information System:
C11 and C13 Engines for Caterpillar Built Machines Inlet Manifold - Remove
C11 and C13 Engines for Caterpillar Built Machines Inlet Manifold - Install
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Transformer (T12 to T16 )
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Controller Board Battery - Replace
SPF343 and SPF343C Trailer Mounted Pumpers Air Shutoff - Replace
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Thermal Switch Monitor PWA
3500 Generator Sets with Dynamic Gas Blending Air Shutoff - Test
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys General Purpose Interface PWA (4 Wire Transformer Cabinet)
2006/10/09 New Test Kits for the Coolant {1395}
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Transfer to Bypass Mode (MMS)
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Front Door Status Indicator Panel
C15 On-Highway Engine Air Inlet and Exhaust System - Inspect
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies System Voltage - Calibrate
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Current Transformers (Primary, Secondary)
C9 Engine for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Flywheel Operating Parameters
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys UPS Messages
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Graphical User Interface Messages
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Flywheel Messages
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys UPS View Commands and Hot Keys
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Fan (4 Wire Transformer Cabinet)
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys External Source Sync PWA (4 Wire Transformer Cabinet)
TA19-M2WD and TA19-M4WD Agricultural Transmissions Transmission - Assemble
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies General Information (Cabinet Hardware)