AC Interface PWA (MMS System Cabinet)
Show/hide table
Illustration 1 | g01273197 |
(1) AC Interface Board |
The AC Interface Board (ACI) (1) monitors the voltages that are on the following nodes:
- System Output
- System Bypass
- System Input
The ACI (1) also monitors the bypass currents of the system output.
Refer to Systems Operation, Testing and Adjusting, RENR9988, "Internal Component Preremoval Steps (MMS System Cabinet)" in order to shut down the system and gain access to internal components.
- Disconnect all connectors. Refer to Illustration 2. Verify each labeling on the connector with the location of the wire. Verify each label on each connector.
- Disconnect the ten white plastic standoffs that connect the board (1) to the left panel.
Note: The board (1) must be removed from the standoffs without bending the board (1).
Show/hide table
Illustration 2 | g01273196 |
Diagram of the Board for the AC Interface Board |
- Position the board (1) in the cabinet over the ten white standoffs that are connected to the left panel.
- Push the board (1) onto all the standoffs simultaneously. Verify that all standoffs are locked in place.
- Connect the wire connectors into the correct connectors on the board (1). Check the labels on each connector for proper placement. Refer to Illustration 2.
- Calibrate the AC Interface Board. Refer to Systems Operation, Testing and Adjusting, RENR9988, "System Voltage - Calibrate" and Systems Operation, Testing and Adjusting, RENR9988, "System Output Current - Calibrate".
Show/hide table
Fuse | Type |
ACI-F1 | 250 VAC, 5 Amperes |
ACI-F2 | 250 VAC, 5 Amperes |
ACI-F3 | 250 VAC, 5 Amperes |
ACI-F4 | 250 VAC, 5 Amperes |
ACI-F6 | 250 VAC, 2 Amperes |
Caterpillar Information System:
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Power Distribution PWA (MMS System Cabinet)
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Parallel Cabinet Interface PWA
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Parallel Cabinet Controller PWA
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Fan Monitor PWA (MMS System Cabinet)
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies EPO Reset Switch (MMS System Cabinet)
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies General Purpose Interface PWA (MMS System Cabinet)
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys 4 Wire Transformer
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Internal Component Preremoval Steps (4 Wire Transformer Cabinet)
G3408C and G3412C Engines Accumulator
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Specifications
G3408C and G3412C Engines Accumulator Pressure - Test
G3408C and G3412C Engines Accumulator
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Flywheel Bearing - Replace
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Transfer to Bypass Mode (SMS)
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys UPS Operating Parameters
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys System Fuse (4 Wire Transformer Cabinet)
C15 On-Highway Engine Air Inlet and Exhaust System - Inspect
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Front Door Status Indicator Panel
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Transfer to Bypass Mode (MMS)
2006/10/09 New Test Kits for the Coolant {1395}
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys General Purpose Interface PWA (4 Wire Transformer Cabinet)
3500 Generator Sets with Dynamic Gas Blending Air Shutoff - Test
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Thermal Switch Monitor PWA
SPF343 and SPF343C Trailer Mounted Pumpers Air Shutoff - Replace