| Required Tools | |||
|---|---|---|---|
| Tool | Part Number | Part Description | Qty |
| A | 180-3032 | Jack Stand Gp | 1 |
| B | 439-3939 | Link Bracket As | 4 |
| C | 8T-4835 | Bolt | 1 |
Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies to prevent fluid loss, and keep contaminants from entering the system.
Note: Cleanliness is an important factor. Before you begin the disassembly procedure, thoroughly clean the exterior. Cleaning the exterior will help to prevent dirt from entering the internal mechanism. Precision components can be damaged by contaminants or by dirt. Perform disassembly procedures on a clean work surface. Keep components covered and protected at all times.
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
- Attach Tooling (B) and a suitable lifting device to the transmission. The weight of the transmission is approximately
1588 kg (3500 lb) . Set the transmission onto Tooling (A) and suitable blocking.Show/hide table
Illustration 2 g01379961 Show/hide table
Illustration 3 g01379962 - Remove bolts (1), cover assembly (2), and gear (3).
- Remove gear (3) from cover assembly (2).
Show/hide table
Illustration 4 g01379963 - Remove bearings (4).
Show/hide table
Illustration 5 g01379964 - Remove cover (5).
Show/hide table
Illustration 6 g01379965 Show/hide table
Illustration 7 g01379966 - Remove bolt (6). Install Tooling (C). Use Tooling (C) in order to remove shaft assembly (7) and thrust washer (8).
Show/hide table
Illustration 8 g01379967 - Remove gear (9), bearing (10), and thrust washer (11).
| |
| Illustration 1 | g01269749 |
