Fuel Pressure Sensor - Remove and Install - Pilot
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect harness assembly (1).
- Remove fuel pressure sensor (2).
Show/hide table
| |
| Illustration 1 | g01266328 |
Show/hide table
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 214-1171 | Socket Wrench | 1 |
| B | 5P-0332 | Crowfoot Wrench | 1 |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install fuel pressure sensor (2). Use Tooling (A) or Tooling (B) in order to tighten fuel pressure sensor (2) to a torque of
20 ± 3 N·m (15 ± 2 lb ft) . - Connect harness assembly (1).
Show/hide table
|
| |
| Illustration 2 | g01266328 |
Caterpillar Information System:
C9 On-highway Engine Electronic Unit Injector Wiring
C7 On-Highway Engine Fuel Pressure Sensor - Remove and Install - Main
C7 On-Highway Engine Coolant Temperature Sensor - Remove and Install
C7 On-Highway Engine Flywheel Housing - Remove and Install
TH48-E70 Petroleum Transmission Lifting and Tying Down the Transmission
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies System Configuration
C7 On-Highway Engine Clean Gas Induction Valve - Assemble
C13 Engine Air Compressor - Remove and Install
3500B Industrial Engines with the ADEM 3 Electronic Control Module Intermediate Speed Switch
C15 On-Highway Engine Fuel Filter Base
2006/07/01 A New Field Service Kit for Alternators is Now Available {1405, 7555}
C13 On-highway Engine Fuel Priming Pump
3500B Industrial Engines with the ADEM 3 Electronic Control Module Overspeed Verify Switch
C13 Engine Crankshaft Position Sensor - Remove and Install
Mechanical Application and Installation Guide for TH48-E70 Petroleum Transmissions{3030, 3101} Mechanical Application and Installation Guide for TH48-E70 Petroleum Transmissions{3030, 3101}
C13 Engine Fuel Temperature Sensor - Remove and Install
C4.4 Industrial Engine Electronic Control System
3500B Industrial Engines with the ADEM 3 Electronic Control Module Permanent Timing Calibration Sensor
3044C Industrial Engine Refill Capacities and Recommendations
C9 On-highway Engine Air Compressor
C13 and C15 On-Highway Engines Engine Operation
C15 On-Highway Engine Electronic Control System Components
C9 Marine Engines and C9 Marine Generator Sets Boost Pressure Sensor
C9 On-highway Engine Jacket Water Heater