Clean Gas Induction Valve - Install
- Install clean gas induction valve (16). Install collar (15). Install stud (17). Connect clip (19). Install nut (18). Install bolt (14).
Show/hide table
Illustration 2 g01257093 Show/hide table
Illustration 3 g01257095 - Position elbow (9). Install stud (11). Install clip (12). Install retainers (8). Install nut (10) and bolt (7). Tighten hose clamp (13). Connect harness assembly (6). Connect hose (5). Tighten hose clamp (4).
Show/hide table
Illustration 4 g01257091 - Connect hose assemblies (2) and (3). Connect harness assembly (1).
Show/hide table
| |
| Illustration 1 | g01257096 |
Caterpillar Information System:
C15 and C18 Petroleum Generator Sets Generator Lead - Check
3500B and 3500C Locomotive Engines Starting Motor System
C7 PETROLEUM Petroleum Engine Cylinder Head - Remove
C4.4 Industrial Engine Fuel System Primary Filter (Water Separator) Element - Replace
Update of the Initial Flash Procedure for the Primary ECM{0785, 7620} Update of the Initial Flash Procedure for the Primary ECM{0785, 7620}
Bench Test Procedure for a CX31 On-Highway Transmission and CX31-P600 Petroleum Transmission {3030, 3073} Bench Test Procedure for a CX31 On-Highway Transmission and CX31-P600 Petroleum Transmission {3030, 3073}
3500B and 3500C Locomotive Engines Sensor Supply
3500B and 3500C Locomotive Engines Pulse Width Modulated Sensor
C4.4 Industrial Engine Introduction
C7 PETROLEUM Petroleum Engine Rocker Arm - Assemble
C7 PETROLEUM Petroleum Engine Rocker Arm and Shaft - Install
C7 On-Highway Engine Fan Drive Mounting Group - Remove and Install
C4.4 Industrial Engine Fuel System Secondary Filter - Replace
C7 On-Highway Engine Combustion Head - Remove and Install
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies System Startup (MMS) - Multiple Module System
C4.4 Industrial Engine Basic Engine
2006/04/01 Replacement Criteria for Camshafts {1210}
2006/04/03 Replacement Criteria for Camshafts {1210}
3500B and 3500C Locomotive Engines Start/Run/Stop Switch
C7 PETROLEUM Petroleum Engine Cylinder Head - Install
2006/05/01 New Location for the Magneto's Vent {1552}
2006/04/17 "Tool and Shop Products Guide" by the Cat Service Technology Group (CSTG) Has Been Replaced by Two New Catalogs {0374}
C7 On-Highway Engine Valve Mechanism Cover Base - Remove and Install
C7 PETROLEUM Petroleum Engine Lifter Group - Remove and Install