Removal Procedure
Show/hide table
Table 1
Required Tools     |
Tool     |
Part Number     |
Part Description     |
Qty     |
A     |
138-7573     |
Link Bracket     |
4     |
B     |
138-7575     |
Link Bracket     |
1     |
Start By:
- Release the hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release".
- Remove the rear hood. Refer to Disassembly and Assembly, "Hood - Remove and Install".
Show/hide table
|
NOTICE |
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
|
Note: Put identification marks on all hoses, on all hose assemblies on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and plug all tube assemblies. This helps prevent fluid loss, and this helps keep contaminants from entering the system.
- Drain the hydraulic tank into a suitable container for storage or disposal.
Show/hide table
|
|
|
Illustration 1 | g01258367 |
- Install Tooling (A) and a suitable lifting device to right fender (1). Remove right fender (1). The weight of right fender (1) is approximately 120 kg (260 lb).
Show/hide table
|
|
|
Illustration 2 | g01258385 |
- Remove ladder (2). Disconnect high speed oil change group (5). Disconnect fuel and water separator base (3). Disconnect primary fuel filter base (4) .
Show/hide table
|
|
|
Illustration 3 | g01258442 |
- Remove bolt (6). Disconnect tube assemblies (7). Remove tube assembly (8) .
Show/hide table
|
|
|
Illustration 4 | g01258450 |
Show/hide table
|
|
|
Illustration 5 | g01258451 |
- Install Tooling (A), Tooling (B), and a suitable lifting device to hydraulic tank (9). The weight of hydraulic tank (9) is approximately 340 kg (750 lb). Remove bolts (10). Remove hydraulic tank (9) .