Flywheel Housing
Show/hide table
图 1 | g02563119 |
Show/hide table
图 2 | g02563117 |
螺栓拧紧顺序 |
Show/hide table
技术规格,用于 135-7634 飞轮壳体总成 | |||
项目 | 数量 | 零件 | 技术规格说明 |
在安装飞轮壳之前,检查飞轮壳的前端面和缸体的后端面。 这些部件必须没有以下物质:机油、燃油、水、密封垫粘合剂、组装固定胶和任何其他异物。 | |||
要密封飞轮壳体与缸体之间的接合处,向飞轮壳体的配合面上涂覆超蓝 Loctite 587。 | |||
按照以下步骤拧紧飞轮壳螺栓: | |||
1 | 9 | 5J-5793 螺栓 | 1. 按图 2 至 2. 按图 2 至 按图 2 至 |
2 | 5 | 0S-1571 螺栓 | |
3 | 2 | 0T-0573 螺栓 | |
4 | 8 | 0S-1591 螺栓 |
Caterpillar Information System:
C1.5 and C2.2 Generator Set Engines Engine Oil Pressure Switch - Remove and Install
C1.5 and C2.2 Generator Set Engines Coolant Temperature Switch - Remove and Install
345C MHPU Mobile Hydraulic Power Unit Machine Systems Swing Drive - Disassemble
C15 and C18 Engines for Caterpillar Built Machines Water Temperature Regulator Housing
C4.4 and C6.6 Engines for Caterpillar Built Machines ECM Harness Connector Terminals
345C MHPU Mobile Hydraulic Power Unit Machine Systems Swivel - Assemble
C1.5 and C2.2 Generator Set Engines Connecting Rod Bearings - Install
C1.5 and C2.2 Generator Set Engines Connecting Rod Bearings - Remove
C15 Generator Set Engines E255 Diagnostic Reset
C15 Generator Set Engines Ether Injection System - Test
3412 Generator Set Engines Fuel Transfer Pump
3412 Generator Set Engines Fuel Transfer Pump
C1.5 and C2.2 Generator Set Engines V-Belts - Remove and Install
345C MHPU Mobile Hydraulic Power Unit Machine Systems Swing Drive - Assemble
345B Excavator Fire Extinguisher Location
C27 and C32 Generator Set Engines Poor Acceleration or Response
C175 Generator Set Engines Flywheel - Remove and Install
C9-XQ300 Rental Generator Set Battery Disconnect Switch
C9-XQ300 Rental Generator Set Circuit Breakers - Reset
C9 Urban Transit Bus Engine Low Power/Poor or No Response to Throttle
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines Multiposition Switch Setup
C-12 Generator Set Engine Noise Coming from Cylinder
3412 Generator Set Engines Automatic Timing Advance Unit
3412 Generator Set Engines Automatic Timing Advance Unit