Speed Sensor
Show/hide table
 | |
| Illustration 1 | g01460887 |
- Install the engine speed sensor into the 5/8 threaded hole and turn until the magnetic core makes contact with a tooth of the flywheel ring gear.
- Back out the engine speed sensor to 180 ± 15 degrees.
- Tighten the locknut (1) to 25 ± 5 N·m (18 ± 4 lb ft).
Clearance between the engine speed sensor and the flywheel ring gear ... 0.56 to 0.84 mm (0.022 to 0.033 inch)
Operating temperature ... -40 to 120 °C (-40 to 248 °F)
Caterpillar Information System:
C175 Generator Set Engines Engine Oil Cooler - Install
C6.6 Industrial Engine Electronic Control System
Guideline for Examining Failed Parts{1000, 7000} Guideline for Examining Failed Parts{1000, 7000}
C9 On-highway Engine Water Pump
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines Throttle Setup
C15 Petroleum Generator Set Engines Engine Oil Lines
C32 Petroleum Engines Fuel Priming Pump - Remove and Install
C175 Generator Set Engines Engine Oil Cooler - Remove
C6.6 Engines for Caterpillar Built Machines Fuel System - Inspect
C7.1 Engines for Caterpillar Built Machines Engine Oil Cooler - Inspect
C6.6 Engines for Caterpillar Built Machines Fuel System - Prime
C27 and C32 Generator Set Engines E198 Low Fuel Pressure
C15 Generator Set Engines Electrical Power Supply Circuit - Test
C9-XQ300 Rental Generator Set Additional Messages
2005/09/01 New Software is Now Used {7620}
G3500 Engines Manual Stop Procedure
C32 Petroleum Engines Fuel Filter Base - Remove
C32 Petroleum Engines Fuel Filter Base - Install
C175-16 and C175-20 Engines for Caterpillar Built Machines Engine Oil Pump - Disassemble
C32 Petroleum Engines Fuel Filter Base - Disassemble
G3500 Engines Turbocharger
C15 and C18 Engines for Caterpillar Built Machines Exhaust Manifold
C32 Petroleum Engines Fuel Filter Base - Assemble
3500B Engines Turbocharger - Remove - Rear Mounted Turbocharger