Water Pump
Show/hide table
Illustration 1 | g01541173 |
(2) Water pump shaft |
(A) Distance from the impeller (1) to the face of the housing ... 8.97 ± 0.25 mm (0.353 ± 0.010 inch)
(B) Operating height of the water pump seal assembly ... 12.19 ± 0.13 mm (0.480 ± 0.005 inch)
(C) Distance from the inside groove of the water pump pulley (3) to the face of the housing ... 136.4 ± 0.3 mm (5.37 ± 0.01 inch)
Note: Refer to Disassembly and Assembly for the complete procedure for installing the shaft and seal.
Caterpillar Information System:
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines Throttle Setup
C15 Petroleum Generator Set Engines Engine Oil Lines
C32 Petroleum Engines Fuel Priming Pump - Remove and Install
C175 Generator Set Engines Engine Oil Cooler - Remove
C6.6 Engines for Caterpillar Built Machines Fuel System - Inspect
C7.1 Engines for Caterpillar Built Machines Engine Oil Cooler - Inspect
C6.6 Engines for Caterpillar Built Machines Fuel System - Prime
C27 and C32 Generator Set Engines E198 Low Fuel Pressure
C13, C15, and C18 Tier 4 Final Engines Engine Oil Pan
C27 and C32 Generator Set Engines E096 High Fuel Pressure
C15 Generator Set Engines E085 Engine Shutdown Overridden
C15 Generator Set Engines Event Codes
Guideline for Examining Failed Parts{1000, 7000} Guideline for Examining Failed Parts{1000, 7000}
C6.6 Industrial Engine Electronic Control System
C175 Generator Set Engines Engine Oil Cooler - Install
C15 Petroleum Generator Set Engines Speed Sensor
C15 Generator Set Engines Electrical Power Supply Circuit - Test
C9-XQ300 Rental Generator Set Additional Messages
2005/09/01 New Software is Now Used {7620}
G3500 Engines Manual Stop Procedure
C32 Petroleum Engines Fuel Filter Base - Remove
C32 Petroleum Engines Fuel Filter Base - Install
C175-16 and C175-20 Engines for Caterpillar Built Machines Engine Oil Pump - Disassemble
C32 Petroleum Engines Fuel Filter Base - Disassemble