Removal Procedure
Show/hide table
Table 1
Required Tools     |
Tool     |
Part Number     |
Part Description     |
Qty     |
A     |
1P-2320     |
Combination Puller     |
1     |
Show/hide table
|
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
|
Show/hide table
|
NOTICE |
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
|
Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
- Drain the hydraulic oil tank into a suitable container. Refer to Operation and Maintenance Manual for the correct procedure.
Show/hide table
|
|
|
Illustration 1 | g01133274 |
- Disconnect hose assemblies (2) from gear pump (1) .
Show/hide table
|
|
|
Illustration 2 | g01133283 |
- Loosen bolts (3) and remove gear pump (1) .
Show/hide table
|
|
|
Illustration 3 | g02093955 |
- Remove shim (4) .
Show/hide table
|
|
|
Illustration 4 | g02093958 |
- Remove integral seal (5) .
Show/hide table
|
|
|
Illustration 5 | g02093960 |
- Remove nut (6) .
- Use Tooling (A) and remove gear (7) from gear pump (1) .
Show/hide table
|
|
|
Illustration 6 | g02093962 |
- Remove O-ring seal (8) .
- Remove bolts (10) and remove adapter (11) from gear pump (1) .
- Remove lip seal (9) from adapter (11) .
Show/hide table
|
|
|
Illustration 7 | g02093963 |
- Remove O-ring seal (12) from gear pump (1) .