C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines Caterpillar


CID 1785 FMI 10

Usage:

C4.4 444
Conditions Which Generate This Code:

This diagnostic code is designed to detect the loss of the 5 Volt supply at the sensor connector.

The Electronic Control Module (ECM) detects the following conditions:

  • The engine speed is more than 1000 rpm.

  • The intake manifold pressure is within the acceptable range.

  • No 0262 codes for the 5 Volt supply are active.

  • Diagnostic code 0168-01 is not active.

System Response:

If equipped, the warning light will come on. The diagnostic code will be logged.

The ECM will flag the intake manifold pressure as being invalid. A default value is used for the intake manifold pressure.

Note: Any open circuits or short circuits in the signal wire for the oil pressure may reset this diagnostic.

For engines with an electronically controlled wastegate, the current for the wastegate solenoid will be set to a default value while this code is active. This will cause the engine to have poor acceleration but the default setting will prevent any overpressure in the intake manifold which could be caused by an overspeed of the turbocharger.

The engine will be derated.

This diagnostic code will detect the loss of the 5 Volt supply to the sensor.

Test Step 1. Perform the following diagnostic procedure: Engine Pressure Sensor Open or Short Circuit - Test

Results:

  • OK - STOP

Caterpillar Information System:

345C MHPU Mobile Hydraulic Power Unit Machine Systems Swing Drive - Install
C-12 Generator Set Engine Event Codes
2005/08/01 New Serial Number Prefix {1000}
345C MHPU Mobile Hydraulic Power Unit Machine Systems Swing Drive - Remove
TH48-E80 Oil/Gas Transmission Transfer Gears - Install - Auxiliary
TH48-E80 Oil/Gas Transmission Transfer Gears - Remove - Auxiliary
TH48-E80 Oil/Gas Transmission Transfer Gears - Disassemble - Idler
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Counterbalance Valve (Travel) - Install
TH48-E80 Oil/Gas Transmission Transfer Gears - Install - Idler
TH48-E80 Oil/Gas Transmission Transfer Gears - Remove - Idler
C-12 Generator Set Engine Sensors and Electrical Connectors
TH48-E80 Oil/Gas Transmission Speed Sensor (Transmission) - Install
C-12 Generator Set Engine Ether Injection System - Test
TH48-E80 Oil/Gas Transmission Transfer Gears - Assemble - Idler
TH48-E80 Oil/Gas Transmission Transfer Gears - Disassemble - Auxiliary
TH48-E80 Oil/Gas Transmission Transfer Gears - Assemble - Auxiliary
2005/10/03 Improved Thermocouples are Now Used {7498}
C7 Petroleum Engines Fuel Filter Base
C-12 Generator Set Engine System Configuration Parameters
C9-XQ300 Rental Generator Set Fan Drive Bearing - Lubricate - if equipped
C7 Industrial Engines Fuel Filter Base
C7 On-highway Engine Fuel Filter Base
TH48-E80 Petroleum Transmission Power Train Electronic Control System System Schematic
C-12 Generator Set Engine Analog Sensor Supply Circuit - Test
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.