Crankshaft Seals
Show/hide table
Illustration 1 | g01332235 |
Typical example |
You do not need to remove the engine oil pan in order to install the oil seal.
Note: Some engines also have an oil seal that is installed in the flywheel housing. Refer to Specifications, "Flywheel Housing" for more information.
The sequence for installation of the rear oil seal
(2) Tighten the two fasteners to the following torque
(1) Tighten the two fasteners to the following torque
Loosen both fasteners (2). Install all the other fasteners and tighten all the fasteners to
Caterpillar Information System:
TH48-E80 Oil/Gas Transmission Lockup Clutch and Solenoid Valve (Torque Converter) - Assemble
3456 Generator Sets Manual Stop Procedure
ES12F, UPS 1000S and UPS 1200S Uninterruptible Power Supplys Device Bus Network - Modbus Communications
3456 Generator Sets Starting the Engine - EMCP 3 (If Equipped)
3618 Engine Auxiliary Water Pump - Assemble
TH48-E80 Oil/Gas Transmission Lockup Clutch and Solenoid Valve (Torque Converter) - Disassemble
TH48-E80 Oil/Gas Transmission Lockup Clutch and Solenoid Valve (Torque Converter) - Install
C-12 Generator Set Engine CID 0091 FMI 08 Throttle Position signal abnormal
C15 On-Highway Engine Fuel System - Prime
TH48-E80 Oil/Gas Transmission Lockup Clutch and Solenoid Valve (Torque Converter) - Remove
ES12F, UPS 1000S and UPS 1200S Uninterruptible Power Supplys Starting and Stopping
TH48-E80 Oil/Gas Transmission Gear Pump (Torque Converter and Transmission) - Assemble
2005/07/01 Diagnostic Codes for the Fuel Pressure Sensor {1718, 7620}
3126B Petroleum Engine Air Shutoff - Disassemble
3126B Petroleum Engine Air Shutoff - Assemble
784C and 785C Off-Highway Truck/Tractors Match Tire Size - Dual Tire Configuration
3126B Petroleum Engine Air Shutoff - Install
2005/07/18 A Improved Gasket is Now Available {1151, 1162}
Supplemental Parts and Service Information for the C18 Marine Propulsion Engine {1901, 7470} Supplemental Parts and Service Information for the C18 Marine Propulsion Engine {1901, 7470}
2005/07/01 A Improved Gasket is Now Available {1151, 1162}
C7 and C9 On-Highway Engines Engine Rating Parameters
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0590 - FMI 12
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0700 - FMI 02
G3500 Engines Model View Illustrations