Engine Oil Filter Base - Disassemble
Start By:
- Remove the engine oil filter base and the oil cooler. Refer to Disassembly and Assembly, "Engine Oil Filter Base - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolts (1), washers (2), cover (3), and gasket (4) from oil filter base assembly (7).
- Remove spring (5) and plunger (6) from oil filter base (7).
- Remove valve (8) from oil filter base (7).
Show/hide table
Illustration 1 | g01182356 |
Show/hide table
Personal injury can result from being struck by parts propelled by a released spring force. Make sure to wear all necessary protective equipment. Follow the recommended procedure and use all recommended tooling to release the spring force. |
Caterpillar Information System:
C18 Petroleum Generator Sets Generator Lead Connections
3126B Petroleum Engine Water Temperature Regulator Housing - Remove and Install
C7.1 (Mech) Industrial Engine Gear Group (Front)
Caterpillar 270 Air Compressor Discharge Valve Leakage - Test
Caterpillar 270 Air Compressor Air Compressor Governor - Test and Adjust
Caterpillar 270 Air Compressor Excessive Oil at Exhaust Ports or Air Strainer
Caterpillar 270 Air Compressor Excessive Build-Up and Recover Time
C7.1 (Mech) Industrial Engine Oil Pump
C9 Generator Set Engine Crankcase Breather - Clean
C7.1 Engines for Caterpillar Built Machines Front Housing and Covers
C32 Marine and Auxiliary Marine Engines Engine Oil Filter Base - Remove
C15 On-Highway Engine Electronic Unit Injector - Adjust
3126B Petroleum Engine Water Temperature Regulator - Remove and Install
3126B Petroleum Engine Flywheel - Remove and Install
C32 Marine and Auxiliary Marine Engines Engine Oil Filter Base - Assemble
C32 Marine and Auxiliary Marine Engines Engine Oil Filter Base - Install
C6.6 Engines for Caterpillar Built Machines Crankshaft
C7 and C9 On-Highway Engines Engine Speed - Test
3500 Engines with EUI Option Engine Design
3500 Engines with EUI Option Engine Design
3500 Engines with EUI Option Engine Design
C32 Marine and Auxiliary Marine Engines Engine Oil Cooler - Remove
C7 and C9 On-Highway Engines Turbocharger - Test
Installation Procedure for the Gasket and Front Plate of the 3456 Engine{1151} Installation Procedure for the Gasket and Front Plate of the 3456 Engine{1151}