Front Housing and Covers
前壳体必须与缸体表面对齐。 ... + 0.05 to minus 0.05 mm (+ 0.0020 to minus 0.0020 inch)
Show/hide table
图 1 | g01332260 |
对中 |
Show/hide table
图 2 | g01332261 |
典型实例 |
按照图 2 所示的顺序依次将固定螺钉拧紧至以下扭矩。 ...
(1) 将固定前盖到前壳体的螺栓拧紧至以下扭矩。 ...
Show/hide table
图 3 | g00918672 |
典型实例 |
(2) 将连接水泵与前壳体的螺栓拧紧至以下扭矩。 ...
注: 关于水泵的螺栓紧固正确顺序,请参阅 水泵, "规格"。
Caterpillar Information System:
C32 Marine and Auxiliary Marine Engines Engine Oil Filter Base - Remove
C15 On-Highway Engine Electronic Unit Injector - Adjust
C3.3 Industrial Engine Accessory Drive - Remove and Install
Caterpillar 270 Air Compressor Air Compressor Leaks Oil
Caterpillar 270 Air Compressor Air Compressor Leaks Coolant
C7.1 Engines for Caterpillar Built Machines Exhaust Manifold
C7.1 Engines for Caterpillar Built Machines Flywheel
C6.6 Industrial Engine Fuel Priming Pump
C6.6 Engines for Caterpillar Built Machines Fuel Injection Lines
C6.6 Industrial Engine Fuel Transfer Pump
C9 Generator Set Fuel System - Prime
C15 and C18 Petroleum Generator Sets After Starting Engine
C9 Generator Set Engine Crankcase Breather - Clean
C7.1 (Mech) Industrial Engine Oil Pump
Caterpillar 270 Air Compressor Excessive Build-Up and Recover Time
Caterpillar 270 Air Compressor Excessive Oil at Exhaust Ports or Air Strainer
Caterpillar 270 Air Compressor Air Compressor Governor - Test and Adjust
Caterpillar 270 Air Compressor Discharge Valve Leakage - Test
C7.1 (Mech) Industrial Engine Gear Group (Front)
3126B Petroleum Engine Water Temperature Regulator Housing - Remove and Install
C18 Petroleum Generator Sets Generator Lead Connections
C32 Marine and Auxiliary Marine Engines Engine Oil Filter Base - Disassemble
3126B Petroleum Engine Water Temperature Regulator - Remove and Install
3126B Petroleum Engine Flywheel - Remove and Install