302.5C Mini Hydraulic Excavator Machine Systems Caterpillar

Removal Procedure

Start By:

1. Remove the seat. Refer to Disassembly and Assembly, "Seat - Remove and Install".
2. Remove the heater assembly. Refer to Disassembly and Assembly, "Heater Core - Remove and Install".
3. Remove the pilot valves. Refer to Disassembly and Assembly, "Pilot Valve (Joystick) - Remove".

Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.

Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.

Show/hide table



Illustration 1	g01179536

1. Disconnect cable assembly (1). Remove console (2) .

Show/hide table



Illustration 2	g01179581

2. Remove two bolts (4). Position the hose assemblies and harness assemblies out of the way and remove plate assembly (3) .

3. Remove floor mat (5) .

Show/hide table



Illustration 3	g01179737

4. Position hose assemblies (7) through support assembly (6). Disconnect cable assembly (1) from support assembly (6). Remove support assembly (6). Remove grommet (8) and position cable assembly (1) through the floorplate.

Show/hide table



Illustration 4	g01179760

5. Disconnect harness assembly (9). Remove guard assembly (10) .

Show/hide table



Illustration 5	g01179772

6. Disconnect cable assembly (11) and harness assemblies (12) and remove the mounting hardware.

Show/hide table



Illustration 6	g01179835

7. Disconnect bracket assembly (14). Disconnect harness assembly (15) .

8. Remove bolts (16) and position support assembly (13) to the side.

Show/hide table



Illustration 7	g01179863

9. Disconnect hoses (17) and position hoses (17) through the grommets. Remove panel (18) .

Show/hide table



Illustration 8	g01179888

10. Remove floorplates (19) .

Show/hide table



Illustration 9	g01179900

11. Disconnect six hose assemblies (21). Remove bolts (22) .

12. Remove swing motor (20) and the O-ring seal.