Swivel - Disassemble
Disassembly Procedure
Start By:
- Remove the swivel. Refer to Disassembly and Assembly, "Swivel - Remove".
- Remove flange mounting bolts (7) .
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Show/hide table
Illustration 1 | g01176351 |
- Remove flange (6) .
- Remove retaining ring (5) .
- Remove spacer (4) and seal (3) .
- Remove shaft (1) upward from housing (2). It may be necessary to tap the base of shaft (6) with a soft hammer in order to remove the shaft.
- Once shaft (6) is removed, remove seals and backup rings (8) from housing (2) .
- Remove seal (1A) from shaft (1) .
Caterpillar Information System:
301.6C and 301.8C Mini Hydraulic Excavators Machine Systems Seat - Remove and Install
301.6C and 301.8C Mini Hydraulic Excavators Machine Systems Swivel - Remove
302.5C Mini Hydraulic Excavator Engine Supplement Fuel Transfer Pump - Remove and Install
385C Excavator and 385C MHPU Mobile Hydraulic Power Unitwith UHD Attachment Demolition Boom Removal
302.5C Mini Hydraulic Excavator Engine Supplement Refrigerant Receiver-Dryer - Remove and Install
302.5C Mini Hydraulic Excavator Engine Supplement Refrigerant Compressor - Remove and Install
301.6C and 301.8C Mini Hydraulic Excavators Machine Systems Track - Remove and Install
325C LCR Excavator Machine Systems Stick - Install
325C LCR Excavator Machine Systems Stick - Remove
C15 and C18 Petroleum Generator Sets Engine Oil and Filter - Change
302.5C Mini Hydraulic Excavator Engine Supplement Fuel Filter and Water Separator Base - Remove and Install
2006/03/27 The Reliability and Durability of the Electric Starting Motor Is Increased {1408, 1417, 1453, 7499}
302.5C Mini Hydraulic Excavator Machine Systems Swivel - Assemble
302.5C Mini Hydraulic Excavator Engine Supplement Refrigerant Condenser - Remove and Install
301.6C and 301.8C Mini Hydraulic Excavators Machine Systems Selector Valve (Alternate Pattern Control) - Remove and Install
301.6C and 301.8C Mini Hydraulic Excavators Machine Systems Front Idler, Recoil Spring and Hydraulic Track Adjuster - Remove and Install
301.6C and 301.8C Mini Hydraulic Excavators Machine Systems Final Drive and Travel Motor - Disassemble
301.6C and 301.8C Mini Hydraulic Excavators Machine Systems Final Drive and Travel Motor - Assemble
301.6C and 301.8C Mini Hydraulic Excavators Machine Systems Front Idler - Remove and Install
301.6C and 301.8C Mini Hydraulic Excavators Machine Systems Sprocket - Remove and Install
302.5C Mini Hydraulic Excavator Machine Systems Main Control Valve - Remove
301.6C and 301.8C Mini Hydraulic Excavators Machine Systems Hydraulic Track Adjusters - Remove and Install
322C Excavator Maintenance Interval Schedule
345C Excavators Circuit Breakers - Reset