Electric Starting Motor - Remove and Install
- Disconnect the batteries.
Show/hide table
Illustration 1 g00999973 Typical Example - Place an identification mark on all of the harness assemblies that are connected to the electric starting motor.
- Disconnect ground harness assembly (1) from the electric starting motor.
- Disconnect harness assemblies (2), and (3) from the electric starting motor.
Show/hide table
Illustration 2 g00999956 Typical Example - Remove nuts (5) from the studs.
- Remove electric starting motor (4) from the flywheel housing.
- Install electric starting motor (4) on the flywheel housing.
- Install nuts (5) on the studs. Tighten nuts (5) to a torque of
44 N·m (32 lb ft) .Show/hide tableIllustration 4 g00999973 Typical Example - Connect harness assemblies (2), and (3) to the electric starting motor.
- Connect harness assembly (1) to the electric starting motor.
- Connect the batteries.
Show/hide table
Illustration 3 | g00999956 |
Typical Example |
Caterpillar Information System:
C4.4 Marine Generator Set Engines Fuel Filter Base - Remove and Install
C4.4 Marine Generator Set Engines Speed/Timing Sensor - Remove and Install
C9 Engine for Caterpillar Built Machines Fuel Priming Pump - Remove and Install
3500B and 3500C Generator Set Engines Diagnostic Codes
C4.4 Marine Generator Set Engines Idler Gear (Front) - Install
C4.4 Marine Generator Set Engines Expansion Tank - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Injector Solenoid Circuit - Test
C4.4 Marine Generator Set Engines Idler Gear (Front) - Remove
C13 and C15 On-Highway Engines Engine Oil and Filter - Change
G3400 Engines (EIS) Programmable Parameters
C4.4 Marine Generator Set Engines Engine Oil Pan - Remove and Install
CX38-P892 Well Servicing Transmission General Hazard Information
C4.4 Marine Generator Set Engines Electric Starting Motor - Remove and Install
3500B and 3500C Generator Set Engines MID 036 - CID 0175 - FMI 04 Engine Oil Temperature short to ground
3500B and 3500C Generator Set Engines MID 036 - CID 0799 - FMI 12 Need Service tool update
3500B and 3500C Generator Set Engines MID 036 - CID 0175 - FMI 03 Engine Oil Temperature open/short to +batt
C7 On-highway Engine Cooling System
C9 Engine for Caterpillar Built Machines Fuel Filter Base - Remove and Install
Yellowmark Noise and Roading Homologation Statement {1062} Yellowmark Noise and Roading Homologation Statement {1062}
C9.3 Tier 4 Final Engines Water Pump - Test
2005/05/16 New 3500 Marine Propulsion Software Available {7620}
C4.4 Marine Generator Set Engines Aftercooler - Remove and Install
C280 Marine Auxiliary Engines Too Much Vibration
2005/05/01 New Full Load Settings and New Full Torque Settings are Now Available {7620}