C4.4 Marine Generator Set Engines Caterpillar


Speed/Timing Sensor - Remove and Install

Usage:

C4.4 L1K

Removal Procedure



    Illustration 1g01166881

  1. Disconnect harness assembly (3) from speed/timing sensor (2).

  2. Loosen locknut (1).

  3. Remove speed/timing sensor (2) from the flywheel housing.

Installation Procedure



    Illustration 2g01166881

  1. Install speed/timing sensor (2) into the flywheel housing until contact is made with the flywheel. Back out speed/timing sensor (2) by approximately one half turn.

  2. Tighten locknut (1).

  3. Connect harness assembly (3).

Caterpillar Information System:

C9 Engine for Caterpillar Built Machines Fuel Priming Pump - Remove and Install
3500B and 3500C Generator Set Engines Diagnostic Codes
C4.4 Marine Generator Set Engines Idler Gear (Front) - Install
C4.4 Marine Generator Set Engines Expansion Tank - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Injector Solenoid Circuit - Test
C4.4 Marine Generator Set Engines Idler Gear (Front) - Remove
C13 and C15 On-Highway Engines Engine Oil and Filter - Change
G3400 Engines (EIS) Programmable Parameters
C4.4 Marine Generator Set Engines Engine Oil Pan - Remove and Install
CX38-P892 Well Servicing Transmission General Hazard Information
C7 On-highway Engine Turbocharger
C13 and C15 On-Highway Engines Belts - Inspect/Adjust/Replace
C4.4 Marine Generator Set Engines Fuel Filter Base - Remove and Install
C4.4 Marine Generator Set Engines Electric Starting Motor - Remove and Install
C4.4 Marine Generator Set Engines Electric Starting Motor - Remove and Install
3500B and 3500C Generator Set Engines MID 036 - CID 0175 - FMI 04 Engine Oil Temperature short to ground
3500B and 3500C Generator Set Engines MID 036 - CID 0799 - FMI 12 Need Service tool update
3500B and 3500C Generator Set Engines MID 036 - CID 0175 - FMI 03 Engine Oil Temperature open/short to +batt
C7 On-highway Engine Cooling System
C9 Engine for Caterpillar Built Machines Fuel Filter Base - Remove and Install
Yellowmark Noise and Roading Homologation Statement {1062} Yellowmark Noise and Roading Homologation Statement {1062}
C9.3 Tier 4 Final Engines Water Pump - Test
2005/05/16 New 3500 Marine Propulsion Software Available {7620}
C4.4 Marine Generator Set Engines Aftercooler - Remove and Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.