Housing (Front) - Remove
Start By:
- Remove the alternator. Refer to Disassembly and Assembly, "Alternator - Remove".
- Remove the fuel injection pump. Refer to Disassembly and Assembly, "Fuel Injection Pump - Remove".
- Remove the idler gear. Refer to Disassembly and Assembly, "Idler Gear - Remove and Install".
- Remove the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
- Remove the camshaft gear. Refer to Disassembly and Assembly, "Camshaft Gear - Remove and Install".
- Remove the auxiliary water pump. Refer to Disassembly and Assembly, "Auxiliary - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
- Remove bolts (1). Remove bypass tube (2) from the cylinder head. Remove the O-ring seals from the bypass tube.
Show/hide table
Illustration 2 g01167083 - Remove bolts (5) and bolts (7) that fasten front housing (3) to the cylinder block.
- Remove front housing (3). Remove gasket (6) from the cylinder block and front housing (3).
- Remove gasket (4) from the back side of front housing (3).
Show/hide table
Illustration 3 g01167085 - Remove thrust washer (8) from camshaft (9).
Show/hide table
Illustration 1 | g00995185 |
Caterpillar Information System:
C4.4 Marine Generator Set Engines Air Shutoff - Remove and Install
C4.4 Marine Generator Set Engines Housing (Front) - Install
3500B and 3500C Generator Set Engines Speed Control
C4.4 Marine Generator Set Engines Inlet Manifold - Remove and Install
C4.4 Marine Generator Set Engines Cylinder Head - Install
3500B and 3500C Generator Set Engines Prelubrication System
3500B and 3500C Generator Set Engines Injector Solenoids
3500B and 3500C Generator Set Engines Ether Injection System
3500B and 3500C Generator Set Engines Engine Speed/Timing Sensor
3500B and 3500C Generator Set Engines Engine Sensor Open/Short Test
3500B and 3500C Generator Set Engines Emergency Stop Switch
3500B and 3500C Generator Set Engines Electrical Power Supply
3500B and 3500C Generator Set Engines Starting Motor System
3500B and 3500C Generator Set Engines Analog Sensor - Calibrate
C13 and C15 On-Highway Engines Belts - Inspect/Adjust/Replace
C7 On-highway Engine Turbocharger
CX38-P892 Well Servicing Transmission General Hazard Information
C4.4 Marine Generator Set Engines Engine Oil Pan - Remove and Install
G3400 Engines (EIS) Programmable Parameters
C13 and C15 On-Highway Engines Engine Oil and Filter - Change
C4.4 Marine Generator Set Engines Idler Gear (Front) - Remove
C27 and C32 Engines for Caterpillar Built Machines Injector Solenoid Circuit - Test
C4.4 Marine Generator Set Engines Expansion Tank - Remove and Install
C4.4 Marine Generator Set Engines Idler Gear (Front) - Install