Rocker Shaft
Show/hide table
| |
| Illustration 1 | g00819372 |
Note: Before assembly, lubricate the components with clean engine oil.
(1) Tighten the nuts and bolts for the housing of the rocker shaft to the following torque. ...
(2) Housing for the rocker shaft assembly
(3) Seal
Show/hide table
| |
| Illustration 2 | g00819413 |
(4) Rocker shaft
- Diameter of the rocker shaft ...
14.95 to 14.97 mm (0.5886 to 0.5894 inch)
- Service limit ...
14.87 mm (0.5854 inch)
(5) Stud
Show/hide table
| |
| Illustration 3 | g00819419 |
(6) Tighten the locknut to the following torque. ...
(7) Adjustment screw for the rocker arm
(8) Rocker arm
(9) Rocker arm clearance on the rocker shaft
- Minimum permissible clearance ...
0.030 to 0.093 mm (0.00120 to 0.00366 inch)
- Maximum permissible clearance ...
0.2 mm (0.008 inch)
Caterpillar Information System:
C2.2 Engine Engine Design
C2.2 Engine and C1.5 Generator Set Fuel Injection Timing - Check
C2.2 Engine and C1.5 Generator Set Troubleshooting
C6.6 Industrial Engine Reference Material
C2.2 Engine and C1.5 Generator Set Basic Engine
C2.2 Engine and C1.5 Generator Set Cooling System
C2.2 Engine and C1.5 Generator Set Glow Plugs
C2.2 Engine and C1.5 Generator Set Lubrication System
C2.2 Engine and C1.5 Generator Set Engine Oil Pressure Switch
C2.2 Engine and C1.5 Generator Set Air Inlet and Exhaust System
C2.2 Engine and C1.5 Generator Set Electric Starting Motor
C2.2 Engine and C1.5 Generator Set Alternator and Regulator
C2.2 Engine Cylinder Head Valves
3500 Engines High Altitude Derate
C2.2 Engine Cylinder Head
C2.2 Engine Exhaust Manifold
C2.2 Engine Engine Oil Relief Valve
C2.2 Engine and C1.5 Generator Set Engine Valve Lash - Inspect/Adjust
C2.2 Engine Water Temperature Regulator
C2.2 Engine Crankshaft
C2.2 Engine Connecting Rod Bearing Journal
C2.2 Engine Piston and Rings
C2.2 Engine Gear Group (Front)
C2.2 Engine and C1.5 Generator Set Piston Ring Groove - Inspect