Auxiliary Water Pump - Remove
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 拆下螺栓、座圈以及将管 (1)固定到辅助水泵 (8)上弯管的挡圈 (2)。
- 拆下螺栓、座圈以及将管 (5)固定到恒温控制阀组件 (9)的挡圈 (4)。
- 拆下将恒温控制阀总成 (9)固定到支架 (10)的螺栓 (6)。
- 恒温控制阀总成 (9) 的重量约为
28 kg (62 lb) 。 用一个合适的举升设备拆下恒温控制阀总成 (9)。 拆下将恒温控制阀总成 (9)固定到辅助水泵 (8)的螺栓 (3)。 拆下恒温控制阀总成 (9)。 - 应辅助水泵 (8)以及附件驱动轴和附件驱动齿轮视为一个整体拆卸。 辅助水泵 (8)、附件驱动轴以及附件驱动齿轮的重量约为
48 kg (106 lb) 。 用一个合适的举升设备将辅助水泵 (8)、附件驱动轴和附件驱动齿轮拆下。 拆下将辅助水泵 (8)固定到前驱动壳体的螺栓 (7)。 将辅助水泵 (8)、附件驱动轴和附件驱动齿轮作为一个整体拆卸。Show/hide table
图 2 g01141236 - 拆下将附件驱动齿轮 (12)固定到附件驱动轴 (13)的螺栓 (11)。
Show/hide table
图 3 g01141237 - 拆下将附件驱动轴 (13)固定到辅助水泵 (8)的螺栓 (14)和止推垫圈 (15)。
Show/hide table
| |
| 图 1 | g01141238 |
Caterpillar Information System:
DE Series Generator Set with Cat C1.1, C1.5, and C2.2 Engines Generator Lead Connections
2005/04/25 Cover Plate, Flange are Available for Use During Flow Tests on the Main Hydraulic Pumps {0738, 5070, 5084}
C1.5 GEN SET Electric Power Generation Refill Capacities and Recommendations
2013/09/27 Test Kit Allows Technician to Check Air Systems with Bendix Air Compressors {0701, 1803}
Electronic Installation Guide{1000} Electronic Installation Guide{1000}
Reuse and Salvage for Cast Iron Cylinder Blocks {1201, 1201} Reuse and Salvage for Cast Iron Cylinder Blocks {1201, 1201}
2005/02/21 Information Release Memo, PELJ0481 , "Product Line Expansion for Caterpillar Low and Medium Pressure Hose and Coupling Products" {5057}
C9 Urban Transit Bus Engine Air Compressor - Remove and Install
PM820, PM822, and PM825 Cold Planer Roading the Machine
2005/01/31 The Connections for Engine Lockout Must be Wired in order to Start the Engine {1450}
C7 and C9 Engines for Caterpillar Built Machines E096 High Fuel Pressure
3500 Petroleum Engines and Petroleum Generator Sets Control Panel
Reuse Guideline for Hydraulic Cylinder Position Sensor {5574, 5736} Reuse Guideline for Hydraulic Cylinder Position Sensor {5574, 5736}
3500 Engines Auxiliary Water Pump - Disassemble
3500 Engines Auxiliary Water Pump - Assemble
3508B, 3512B and 3516B Generator Set Engines Exhaust Elbow - Remove and Install
374F Excavator Bucket Linkage - Inspect/Adjust
C15 and C18 Engines for Caterpillar Built Machines Diagnostic Codes
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers CID 0262 FMI 03 5 Volt Sensor DC Power Supply short to +batt
C27 and C32 Engines for Caterpillar Built Machines E194 High Exhaust Temperature
C27 and C32 Generator Set Engines E361 High Engine Coolant Temperature
C27 and C32 Engines for Caterpillar Built Machines E362 Engine Overspeed
345C MHPU Mobile Hydraulic Power Unit Hydraulic System Fan Motor (Hydraulic and Radiator Cooling)
C27 and C32 Engines for Caterpillar Built Machines E360 Low Engine Oil Pressure