R1300G Series II Load Haul Dump Caterpillar


Fuel System Primary Filter (Water Separator) - Replace

Usage:

R1300G II RSL
当发动机功率下降或排气冒黑烟时,更换粗滤芯。

------ WARNING! ------

发动机运转时,不要松开任何高压燃油管。燃油管路中高压回引起人身伤亡。在对发动机燃油管路进行任何保养或修理前,发动机停止后等待 60 秒钟,允许排放压力。


------ WARNING! ------

如果喷溅燃油点火,会造成人身伤亡。 泄漏或溅溢到热表面或电气部件上的燃油会引起失火。

为防止可能的伤害,当更换燃油滤清器或油水分离器滤芯时,要将蓄电池断路开关转到断开位置。 应立即将溅溢的燃油清除干净。



注意

在检验、保养、测试、调整及维修产品时,务必留心,确保液体盛装在容器中。 在打开任何腔室或拆解任何储有液体的部件之前,要准备好用合适的容器收集液体。

有关适合收集和盛接卡特彼勒产品上液体的工具及用品,参考专门出版物, NENG2500, "卡特彼勒工具和修理车间设备指南"。

按照当地法规和指令处置所有液体。



注意

安装燃油滤清器之前不要在其中注入燃油。 否则燃油不会被过滤并可能受污染。 污染的燃油会加速燃油系统部件的磨损。 起动发动机之前应向燃油系统充注油。





图 1g01138547

  1. 用带式扳手从底座上卸下燃油滤清器组件 (1) 。

  1. 从滤芯上卸下沉淀杯 (2) 和密封并废弃旧滤清器。 检查密封圈。 如果密封圈损坏,安装一个新的。

  1. 清洁滤清器安装底座。 确保将所有旧的密封已去除。

  1. 在清洁、不易燃的溶剂中清洗沉淀杯 (2) 。

  1. 在新的滤清器密封上涂上干净柴油。

  1. 将密封和沉淀杯 (2) 安装在新的粗滤芯上。

  1. 用手安装新的滤清器组件。 拧紧滤清器组件,直到密封面接触到底座。 再拧紧滤清器组件 3/4 圈。

    注: 每个滤清器上有旋转标记,间隔90度(1/4圈)。 在紧固滤清器时,用这些标记作参考。

  1. 向燃油系统充油。

    参考关于被维修机器的燃油系统充注的详细资料,参阅操作和保养手册, "燃油系统 - 充油"。

  1. 起动发动机,并检查滤清器有无泄漏。 进行所有必要的修理。 如果发动机功率丧失或排气仍冒黑烟,更换细滤清器。

    参考关于被维修机器的更换燃油细滤清器的详细资料,参阅操作和保养手册, "燃油系统细滤清器 -更换"。

Caterpillar Information System:

824H Wheel Dozer, 825H Soil Compactor and 826H Landfill Compactor Electrohydraulic System Hydraulic Fan System
824H Wheel Dozer, 825H Soil Compactor and 826H Landfill Compactor Electrohydraulic System Pilot Pressure to the Main Control Valve - Check
C9 Industrial Engines Plate Locations and Film Locations
RM-300 Reclaimer Mixer Machine Systems Air Cleaner
CB-634D Vibratory Compactor Vibratory System Piston Pump Neutral - Test and Adjust
824H Wheel Dozer, 825H Soil Compactor and 826H Landfill Compactor Electrohydraulic System Relief Valve (Main) - Test and Adjust
735 and 740 Articulated Trucks Crankshaft Vibration Damper - Inspect
824H Wheel Dozer, 825H Soil Compactor and 826H Landfill Compactor Electrohydraulic System Hydraulic Fan Speed - Test and Adjust
3508B Engine for Caterpillar Built Machines Flywheel Housing
834H Wheel Dozer and 836H Landfill Compactor Steering System Piston Pump (Steering)
CB-634D Vibratory Compactor Vibratory System Relief Valve (Pressure Override) - Test and Adjust
TH580B Telehandler Machine Systems Cab - Remove
R1300G Series II Load Haul Dump Fuel System Secondary Filter - Replace
824H Wheel Dozer, 825H Soil Compactor and 826H Landfill Compactor Electrohydraulic System Torque Converter Stall and Implement Pump Double Stall - Test
735 and 740 Articulated Trucks Engine Compression Brake Valve Lash - Check
834H Wheel Dozer and 836H Landfill Compactor Electrohydraulic System MID 082 - CID 0168 - FMI 01
735 and 740 Articulated Trucks Engine Crankcase Breather - Clean
R1300G Series II Load Haul Dump Fuel Tank Cap and Strainer - Clean
824H Wheel Dozer, 825H Soil Compactor and 826H Landfill Compactor Electrohydraulic System Pump Performance (Implement) - Test
R1300G Series II Load Haul Dump Fuel Tank Water and Sediment - Drain
R1300G Series II Load Haul Dump Fuses - Replace
307D, 311D, 312D, 313D, 315D, 318D, 319D, 320D, 323D, 324D, 325D, 326D, 328D, 329D, 330D, 336D, 340D, 345D, 349D, 374D, 390D and M325D Excavators Air Conditioning and Heating Pressure Switch (Refrigerant Pressure Cutoff)
824H Wheel Dozer, 825H Soil Compactor and 826H Landfill Compactor Electrohydraulic System Piston Motor (Hydraulic Fan)
264-9894 Control Gp-Parking Brake (Automatic) Custom Product Support Literature for the R2900G <B>S/N:</B>GLK1-UP Load Haul Dump{1408, 4250} 264-9894 Control Gp-Parking Brake (Automatic) Custom Product Support Literature for the R2900G <B>S/N:</B>GLK1-UP Load Haul Dump{1408, 4250}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.