3126B Petroleum Engine Caterpillar


Diagnostic Code Cross Reference

Usage:

3126B Z2A
Problems with the electronic control system are reported via these types of codes: flash codes, SPN/FMI codes, diagnostic codes and event codes.

For information on flash codes, refer to Troubleshooting, "Flash Codes".

For information on SPN/FMI codes, refer to Troubleshooting, "Diagnostic Codes".

For information on diagnostic codes, refer to Troubleshooting, "Diagnostic Codes".

For information on event codes, refer to Troubleshooting, "Event Codes".

Use Table 1 as a cross-reference between the various types of codes.

Portions of this material are reprinted with permission from SAE J1939DA_201607© 2016 SAE International. SAE International is not responsible for any use or translation of this material, in whole or in part. Please contact SAE International to obtain a complete copy of SAE J1939DA_201607, the official definitive source of this standard.

Table 1
Cross Reference for Diagnostic Codes 
Flash Code  Diagnostic Code
or
Event Code 
SPN/FMI Code  Description of Code 
N/A  E443-1  1387-15  High Auxiliary Pressure Warning 
E443-2 1387-16  High Auxiliary Pressure Derate 
E443-3 1387-00  High Auxiliary Pressure Shutdown 
E444-1 1387-17  Low Auxiliary Pressure Warning 
E444-2 1387-18  Low Auxiliary Pressure Derate 
E444-3 1387-01  Low Auxiliary Pressure Shutdown 
E445-1 441-15  High Auxiliary Temperature Warning 
E445-2 441-16  High Auxiliary Temperature Derate 
E445-3 441-00  High Auxiliary Temperature Shutdown 
E446-1 441-17  Low Auxiliary Temperature Warning 
E446-2 441-18  Low Auxiliary Temperature Derate 
E446-3 441-01  Low Auxiliary Temperature Shutdown 
15  164-02  0164-02  Injector Actuation Pressure Signal erratic 
164-03 0164-03  Injector Actuation Pressure voltage high 
164-04 0164-04  Injector Actuation Pressure voltage low 
17  164-00  0164-00  High Injector Actuation Pressure 
18  042-11  N/A  Injection Actuation Control Valve open/short 
21  262-03  0620-03  5 Volt Sensor DC Power Supply short to +batt 
262-04 0620-04  5 Volt Sensor DC Power Supply short to ground 
263-03 0678-03  Digital Sensor Supply short to +batt 
263-04 0678-04  Digital Sensor Supply short to ground 
24  100-03  0100-03  Engine Oil Pressure open/short to +batt 
100-04 0100-04  Engine Oil Pressure short to ground 
25  273-03  0102-03  Turbo Outlet Pressure open/short to +batt 
273-04 0102-04  Turbo Outlet Pressure short to ground 
26  274-03  0108-03  Atmospheric Pressure open/short to +batt 
274-04 0108-04  Atmospheric Pressure short to ground 
27  110-03  0110-03  Engine Coolant Temperature open/short to +batt 
110-04 0110-04  Engine Coolant Temperature short to ground 
28  91-13  0091-13  Throttle Position calibration required 
32  91-08  0091-08  Throttle Position signal abnormal 
34  320-02  0190-02  Speed/Timing Sensor Loss of Signal 
320-11 0190-11  Speed/Timing Sensor mechanical failure 
342-02 0723-02  Loss of Secondary Engine Speed signal 
342-11 0723-11  Secondary Engine Speed Sensor mechanical failure 
35  E004  0190-16  Engine Overspeed Shutdown 
E190 0190-00  Engine Overspeed Warning 
37  94-03  0094-03  Fuel Pressure open/short to +batt 
94-04 0094-04  Fuel Pressure short to ground 
175-03 0175-03  Engine Oil Temperature open/short to +batt 
175-04 0175-04  Engine Oil Temperature open/short to ground 
38  172-03  0172-03  Intake Manifold Air Temp open/short to +batt 
172-04 0172-04  Intake Manifold Air Temp short to ground 
39  164-11  0164-11  Injector Actuation Press Sensor fault 
42  261-13  0228-13  Engine Timing calibration required 
46  E039  0100-18  Low Engine Oil Pressure Derate 
E040 0100-01  Low Engine Oil Pressure Shutdown 
E100 0100-17  Low Engine Oil Pressure Warning 
49  617-05  0729-05  Air Inlet Heater Relay open/current below normal 
617-06 0729-06  Air Inlet Heater Relay grounded/current above normal 
51  168-02  0168-02  System Voltage intermittent/erratic 
53  254-12  N/A  Electronic Control Module Error 
56  253-02  0234-02  Personality Module mismatch 
268-02 1111-02  Check Programmable Parameters 
58  247-09  0639-09  J1939 Data Link communications 
61  E015  0110-16  High Engine Coolant Temperature Derate 
E016 0110-00  High Engine Coolant Temperature Shutdown 
E017 0110-15  High Engine Coolant Temperature Warning 
62  E057  0111-18  Low Engine Coolant Level Derate 
E058 0111-01  Low Engine Coolant Level Shutdown 
E059 0111-17  Low Engine Coolant Level Warning 
63  E005  0094-15  Fuel Filter Restriction Derate 
E006 0094-16  Fuel Filter Restriction Shutdown 
E095 0094-00  Fuel Filter Restriction Warning 
E096 0094-00  High Fuel Pressure 
64  E025  0172-16  High Inlet Air Temperature Derate 
E027 0172-15  High Inlet Air Temperature Warning 
72  1-11  0651-11  Injector Cylinder #1 fault 
2-11 0652-11  Injector Cylinder #2 fault 
73  3-11  0653-11  Injector Cylinder #3 fault 
4-11 0654-11  Injector Cylinder #4 fault 
74  5-11  0655-11  Injector Cylinder #5 fault 
6-11 0656-11  Injector Cylinder #6 fault 

Caterpillar Information System:

3508C, 3512C and 3516C Marine Engines Flywheel - Remove and Install
3508C, 3512C and 3516C Marine Engines Accessory Drive (Front) - Assemble
3508C, 3512C and 3516C Marine Engines Accessory Drive (Front) - Disassemble
345C Excavator Machine System Specifications Boom
345C Excavator Machine System Specifications Final Drive
C7 Engines for Caterpillar Built Machines Connecting Rod Bearings - Install
568 Forest Machine Machine System Specifications Recoil Spring
C9 Marine Generator Set Product Lifting
C32 Marine Engines System Configuration Parameters
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Flash Programming
C9 Engines for Caterpillar Built Machines Basic Engine
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Camshaft - Assemble
3508B, 3512B and 3516B Generator Set Engines Flywheel Housing - Remove
3508B, 3512B and 3516B Generator Set Engines Flywheel Housing - Install
2004/12/01 Correct Wiring Diagrams Have Been Identified for 480 Volt Sensing VR3 to VR6 Regulator Conversion {4467}
2004/12/01 New Lockwasher Will Improve Varistor Reliability {4466}
C7.1 Industrial Engine Engine Stopping
C4.4 Industrial Engine Electrical System
C11 and C13 Engines for Caterpillar Built Machines General Information
C11 and C13 Engines for Caterpillar Built Machines Lubrication System
G3520C and G3520E Generator Set Engines Fuel Control Valve - Remove and Install
3126B Petroleum Engine Injection Actuation Pressure - Test
C6.6 Industrial Engine Model View Illustrations
3500 and 3500B Engines Reference Numbers
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.