414E, 416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Engine Supplement Caterpillar


Radiator, Refrig Condenser, and Hyd and TMSN Oil Cooler - Install

Usage:

416E CBD

安装步骤

表 1
所需工具    
工具     零件号     零件描述     数量    
A     138-7575     连杆支架     2    



    图 1g01114039



    图 2g01113927

  1. 将工具 (A) 和适当的起吊设备安装到散热器、制冷剂冷凝器、液压油冷却器和变速箱油冷却器 (15) 上。 散热器、制冷剂冷凝器、液压油冷却器和变速箱油冷却器 (15) 的重量约为 91 kg (200 lb)。

  1. 安装散热器、制冷剂冷凝器、液压油冷却器和变速箱油冷却器 (15) 。 安装螺栓 (16) 。 安装油封 (14) 。



    图 3g01114025

  1. 连接软管 (11) 。 连接夹子 (13) 。 安装支架 (12) 。



    图 4g01113976

  1. 连接软管 (10) 。 安装夹子 (9) 。



    图 5g01113955

  1. 安装支架 (8) 。 连接软管 (6) 和软管组件 (7) 。



    图 6g01113968

  1. 连接软管组件 (4) 和软管 (5) 。 安装夹子 (3) 。



    图 7g01114034

  1. 连接上部散热器软管 (2) 。



    图 8g01113973

  1. 连接下部散热器软管 (1) 。

  1. 加注发动机冷却液。 请参阅操作和保养手册, "冷却系统冷却液(ELC)- 更换"。

  1. 加注变速箱机油。 请参考操作和保养手册, "变速箱油 - 更换"。

  1. 加注液压油。 请参阅操作和保养手册, "液压系统机油 - 更换"。

  1. 加注空调系统。 请参阅维修手册, SENR5664, "使用 R-134a 制冷剂的空调与暖风系统",了解相关正确步骤。 请参阅专门出版物, NEDG5065, "空调工具"了解正确工具信息。

  1. 安装发动机罩。 请参考拆解和装配, "发动机罩 - 拆卸和安装"。

End By: 安装风扇。 请参阅 拆解和组装, "风扇 - 拆卸和安装"。

Caterpillar Information System:

2004/11/08 New Engine Software Corrects Warnings of Air Filter Inlet Air Restriction {7620}
3508C, 3512C and 3516C Marine Engines Engine Oil Filter Housing - Assemble
3508C, 3512C and 3516C Marine Engines Engine Oil Filter Housing - Disassemble
C9 Engines for Caterpillar Built Machines Vibration Damper and Pulley
143H and 163H Motor Graders Power Train Tandem and Cover - Remove and Install
414E, 416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Engine Supplement Radiator, Refrig Condenser, and Hyd and TMSN Oil Cooler - Remove
12H, 140H and 160H Motor Graders Power Train Tandem and Cover - Remove and Install
583T Pipelayer Engine Supplement Prelubrication Oil Pump - Install
AP-1055D and BG-2455D Asphalt Pavers Daily Inspection
CB-214E, CB-224E and CB-225E Vibratory Compactors Machine Systems Piston Pump (Propel) - Assemble
CB-214E, CB-224E and CB-225E Vibratory Compactors Machine Systems Piston Pump (Propel) - Disassemble
16M Series 3 and 18M Series 3 Motor Graders Wheel Lean Bearings - Lubricate
PS-360C Pneumatic Compactor Machine System Additive Spray System Troubleshooting
PS-360C Pneumatic Compactor Machine System Check Valves (Air on the Run) - Check
583T Pipelayer Power Train Main Drive Shaft - Remove and Install
414E, 416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Engine Supplement Hydraulic and Transmission Oil Cooler - Remove
C11 and C15 Engines for Caterpillar Built Machines Injector Solenoid Circuit - Test
2004/10/18 Correction to Operation and Maintenance Manual , "Tire Inflation Information" {4203}
267B, 277B and 287B Multi Terrain Loaders Machine Systems Pilot Hydraulic System
PS-360C Pneumatic Compactor Machine System Air on the Run System Troubleshooting
PS-360C Pneumatic Compactor Machine System Pressure Switch (Air on the Run System Pressure) - Test and Adjust
414E, 416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Engine Supplement Hydraulic and Transmission Oil Cooler - Install
834H Wheel Dozer and 836H Landfill Compactor Braking System General Information
267B, 277B and 287B Multi Terrain Loaders Machine Systems Hydrostatic System
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.