Fuel Transfer Pump
Show/hide table
图 1 | g02543779 |
(1) 溢流孔
(2) 压力调节阀 (3) 进口 (4) 出口 |
Show/hide table
316-6864 输油泵总成、 316-6863 输油泵总成、 295-9260 输油泵总成、 295-9261 输油泵总成、 272-5930 输油泵总成、 316-6865 输油泵总成和 290-8866 输油泵和注油泵总成的技术规格 | |||
项目 | 数量 | 零件 | 技术规格说明 |
- | - | - | 当燃油输油泵使用柴油时,燃油输油泵具有以下技术规格: |
使泵在 2940 rpm 转速下运转。 整个旁通压力应为 |
|||
使泵在 840 rpm 转速下运转。 在 |
|||
使泵在 2940 rpm 转速下运转。 在 |
|||
使泵在120 rpm 转速下运转。 保持进口对空气打开 10 秒钟。 封闭进口。 泵必须能保持 |
|||
使泵在 840 rpm 转速下运转。 保持进口对空气打开 10 秒钟。 封闭进口。 泵必须能保持 |
|||
封闭进口让泵在 120 rpm 转速下运转 30 秒钟。 泵的进口必须具备最小为 |
Caterpillar Information System:
XQ125 Generator Set Driven Equipment - Check
C15 and C18 Industrial Engines Flywheel Housing - Remove and Install
G3500 Engines Cooling System Coolant (NGEC) - Change
3500 Industrial Engines Auxiliary Water Pump
C7 Marine Engines Engine Sensors - Remove and Install
C7 Marine Engines Fuel Cooler - Remove and Install
C4.4 (Mech) Industrial Engine Battery or Battery Cable - Disconnect
C4.4 (Mech) Industrial Engine Battery - Replace
3126E Truck Engines Reference Material
TH31-C9I, TH31-C9P, TH31-C9T, TH35-C13I, TH35-C13T, TH35-C15I and TH35-C15T Petroleum Power Train Packages and TH31-E61 and TH35-E81 Petroleum Transmissions Transmission Oil Filter (Transmission)
G3406 Engines Cylinder Head Valves
G3500B Engines Engine Oil Lines
C3.3 Industrial Engine Engine Air Cleaner Element (Single Element) - Inspect/Replace
C13, C15, and C18 Tier 4 Final Engines Electronic Unit Injector
C18 Generator set and C18 Marine Engines Flywheel - Remove
C18 Generator set and C18 Marine Engines Flywheel - Install
G3500 Engines Starting the Engine
C15 and C18 Industrial Engines Camshaft - Install
C15 and C18 Industrial Engines Camshaft - Remove
C13, C15, and C18 Generator Set Engines Speed Control (Switch) - Test
G3500 Generator Sets Cooling System Coolant (NGEC) - Change
C15 and C18 Industrial Engines Alternator - Remove and Install
3500 and 3500B Engines Electrical System
3516B and 3516B High Displacement Engines for 994D and 994F Wheel Loaders Crankcase Pressure Sensor