3412E, C30 and C32 Marine Engines Caterpillar


Water Pump - Install

Usage:

3412E 9KS

Installation Procedure


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.




    Illustration 1g01090056

  1. Position water pump (12).

  2. Install bolts (10), nuts (9), and bolt (11).


    Illustration 2g01090039

  3. Position tube assembly (2) and tube assembly (4). Position cover (8) and install hoses (6) and bolts (5).

  4. Tighten clamps (7).

  5. Connect tube assembly (2) and tube assembly (4).


    Illustration 3g01090036

  6. Connect tube assembly (4) and tighten clip (3).


    Illustration 4g01090034

  7. Connect tube assembly (2).


    Illustration 5g01090033

  8. Install cover guard (1).

  9. Fill the coolant system. Refer to Operation and Maintenance Manual, "Refill Capacities and Recommendations".

Caterpillar Information System:

2004/07/01 A New Housing for the Speed/Timing Sensor and a New Speed/Timing Sensor are Used {1210, 1907}
EMCP3 ECM Connections
G3500B Engines Throttle Control Valve - Check
EMCP3 Electronic Control Module (Generator Set) - Flash Program
EMCP3 Wiring Harness (Short Circuit) - Test
EMCP3 Wiring Harness (Open Circuit) - Test
3412E, C30 and C32 Marine Engines Water Pump - Remove
G3520B Industrial Engine Ignition Transformers Primary Circuit
C15 and C18 Tier 4 Final Engines Inlet Manifold Pressure - Test
G3300 Engines After Stopping Engine
C9 Marine Generator Set Engines Gear Group (Front) - Time
2008/10/06 New Tubes for Plate Type Heat Exchangers that Are Designed To Order (DTO) {1379}
G3520B Industrial Engine Integrated Temperature Sensing Module (ITSM)
2004/08/01 Special Instructions Are No Longer Announced In the Truck Engine News {1000}
2004/08/01 Special Instructions Are No Longer Announced In the Engine News {1000}
2004/10/01 Reduced Oil Change Intervals {7542}
3126E Truck Engines Maintenance Interval Schedule - Engines with a Shallow Oil Sump
3126E Truck Engines Maintenance Interval Schedule - Engines with a Deep Oil Sump
2004/07/01 Some Older Mechanical Unit Injectors are Being Cancelled {1290}
C27 and C32 Industrial and Petroleum Engines Intermittent Low Power or Power Cutout
G3520B Industrial Engine Engine Speed/Timing Sensor - Calibrate
G3520B Industrial Engine Oxygen Sensor - Calibrate
3500B High Displacement Air Inlet and Exhaust Lines
G3520B Industrial Engine Oxygen Sensor Buffer Supply
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.