Electronic Unit Injector Wiring
Show/hide table
图 1 | g01075720 |
典型示例 (1) 发动机线束组件和接头密封件 |
注: 抵着接头表面安装接头密封件的平面部分。 安装密封件的曲面部分时,必须使密封件抵着气门机构盖底座。
(2) 12 个盖组件上的 24 个锁紧螺母的扭矩 ... 2.50 ± 0.25 N·m (22 ± 2 lb in)
注: 调整接头的位置,以便导线不会接触到金属表面。
Caterpillar Information System:
C27 and C32 Engines for Caterpillar Built Machines Electronic Unit Injector Mechanism
2004/09/01 An Improved Auxiliary Water Pump is Introduced {1371}
3406E and 3456 Industrial Engines Air Shutoff Solenoid
C9.3 Engine for Caterpillar Built Machines Piston Cooling Jet
3406E and 3456 Generator Set Engines Poor Acceleration or Response
C9 Marine Engines and C9 Marine Generator Sets Electric Starting Motor
3406E Truck Engines Crankshaft Seals
3406E Truck Engines Crankshaft
C11 and C13 Engines for Caterpillar Built Machines Vibration Damper - Check
C9 Marine Engines and C9 Marine Generator Sets Flywheel Housing
3406E, C-10 and C-12 On-highway Engines 0171-03 Ambient Air Temperature voltage high
325D and 329D Excavators Stopping the Machine
C7 Urban Transit Bus Engines Cooling System Coolant (DEAC) - Change
G3600 Engines Speed Sensor
C15 On-highway Engines Fuel Priming Pump - Remove and Install
G3516B Engines Location of Components
C15 On-highway Engines Fuel Transfer Pump - Remove
C15 On-highway Engines Fuel Transfer Pump - Install
C11 and C13 Petroleum Engines Lubrication System
G3516B Engines Generator Output Power Readings Do Not Match
C15 On-highway Engines Electronic Unit Injector - Remove
G3516B Engines Generator Output Power Sensor
C15 and C18 Generator Set Engines Electronic Unit Injector Sleeve - Remove
C15 and C18 Industrial Engines Electronic Unit Injector Sleeve - Install