Troubleshooting
Show/hide table
Illustration 1 | g01071394 |
(41) Fuses "F3" and "F4"
(42) Diode (43) Capacitors "C1" and "C2" (44) Relays "CR1", "CR2", and "CR3" (46) Contactor "K1" (47) Fuses "F1" and "F2" (48) Transformer "T2" (49) Board Assembly (50) Circuit Breaker Assembly "CB1" (54) Transformer "T1" |
Circuit Breaker "CB1" Opens Immediately After Closure
- Check Fuses "F3" (41 ) and "F4" (41).
- Check DC polarity.
- Check diodes.
"CB1" Closed, Yet the System Has No Output.
- Contactor "K1" (46) is not closed. Check "F1" (47) and "F2" (46).
- Check the voltage on the secondary winding of "T2" (48).
- Check the continuity of the windings of coil "K1" (46).
- Check temperature sensors for "T1" (54) and diodes.
- Check relay "K1" (46).
- Check fuses "F1" (47) and "F2" (46).
- Check "CB1" (50).
- If "CB1" (50) is open and the starting power paralleling option is installed, the output voltage may be from the battery.
Caterpillar Information System:
Generator Set Start Module (AC Input) Model View Illustrations
3406E, C-10 and C-12 On-highway Engines Engine Speed/Timing Sensor Circuit - Test
Generator Set Start Module (AC Input) Symbols
Generator Set Start Module (AC Input) Acronyms
G3520C and G3520E Generator Set Engines Actuator Bypass Valve (Variable) - Install
G3520C and G3520E Generator Set Engines Actuator Bypass Valve (Variable) - Remove
G3520C and G3520E Generator Set Engines Fuel Control Valve - Remove and Install
2004/05/01 UPS Flywheel Bearing Serviceability {7551}
C27 and C32 Engines for Caterpillar Built Machines Turbocharger
G3520C and G3520E Generator Set Engines Throttle Control Valve - Install
G3520C and G3520E Generator Set Engines Throttle Control Valve - Remove
Generator Set Start Module (AC Input) Safety Signs and Labels
3176C and 3196 Engines for Caterpillar Built Machines Flywheel
2004/08/01 The Oil Level Gauge (Dipstick) has been Improved {1326}
C-9 Engine for the 330C Excavator and for the 330C Mobile Hydraulic Power Unit Engine Misfires, Runs Rough or Is Unstable
3406E and 3456 Generator Set Engines Flywheel Housing
C11 and C13 Petroleum Engines Engine Support (Front)
12M Motor Grader Centershift Cylinder Socket - Check/Adjust/Replace
C15 and C18 Industrial Engines Flywheel Housing
12M Motor Grader Centershift Cylinder Socket - Lubricate
12M Motor Grader Circle Drive Pinion Teeth - Lubricate
3406E, C-10 and C-12 On-highway Engines Idle Shutdown Timer - Test
G3520C and G3520E Generator Set Engines Turbocharger - Disassemble - Single Turbocharger
3406E, C-10 and C-12 On-highway Engines PTO Shutdown Timer - Test