Site Preparation
Place the unit in a clean environment. Make sure that you comply with the following standards:
- The area is free of dust.
- Make sure that there is good air circulation around the unit.
- Make sure that the wall can support the weight of the unit.
- Make sure that the floor can support the weight of the unit (including the optional floor mounting kit).
- Make sure that a radius of
914.40 mm (36.00 inch) is maintained for opening the door before installing the Generator Set Start Module. - Make sure that there is
914.40 mm (36.00 inch) of clearance in front of the unit. - Make sure that there are
152.40 mm (6.00 inch) of clearance on the unit's right side. - Make sure that there are
228.60 mm (9.00 inch) of clearance on the unit's left side. This clearance is needed for the entry of the cable and for the circulation of the air. - Make sure that both installations have no less than
304.80 mm (12.00 inch) clearance on top and406.40 mm (16.00 inch) on the bottom. - Make sure that the units are bolted securely to the wall or to the floor. Mounting the unit to the floor requires an optional kit in order to make sure that the installation of the unit is safe and secure.
Caterpillar Information System:
Generator Set Start Module (AC Input) Specifications
Generator Set Start Module (AC Input) System Description
2004/05/03 Improved Service Meter Used {7478}
3406E, C-10 and C-12 On-highway Engines Engine Temperature Sensor Open or Short Circuit - Test
C11 and C13 Petroleum Engines Flywheel Housing
2004/05/01 New Turbocharger Supply Lines are Available {1052, 1071}
3406E, C-10 and C-12 On-highway Engines Engine Pressure Sensor Open or Short Circuit - Test
14L Motor Grader All Wheel Drive Motor Supply Hose - Inspect/Replace - If Equipped
3406E, C-10 and C-12 On-highway Engines Electrical Connectors - Inspect
2004/06/01 An Improved Hose Assembly for the Gauge Assembly is Being Used {7454, 7455, 7456}
3406E, C-10 and C-12 On-highway Engines ECM Memory - Test
12M Motor Grader Circle Drive Oil - Change
Generator Set Start Module (AC Input) Mounting
Generator Set Start Module (AC Input) Electrical Connections
Generator Set Start Module (AC Input) Product Drawings - Interconnection Diagram
Generator Set Start Module (AC Input) Product Drawings - Internal Schematic
Generator Set Start Module (AC Input) Safety Signs and Labels
G3520C and G3520E Generator Set Engines Throttle Control Valve - Remove
G3520C and G3520E Generator Set Engines Throttle Control Valve - Install
C27 and C32 Engines for Caterpillar Built Machines Turbocharger
2004/05/01 UPS Flywheel Bearing Serviceability {7551}
G3520C and G3520E Generator Set Engines Fuel Control Valve - Remove and Install
G3520C and G3520E Generator Set Engines Actuator Bypass Valve (Variable) - Remove
G3520C and G3520E Generator Set Engines Actuator Bypass Valve (Variable) - Install