| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 3/8 by 16 NC by 5 (Guide Bolt) | 2 | |
| B | 138-7573 | Link Bracket | 2 |
| C | 5P-2187 | Lifting Bracket | 1 |
| D | 5P-2184 | Bracket | 1 |
Start By:
- Remove the rear chassis support. Refer to Disassembly and Assembly, "Rear Chassis Support - Remove".
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
- Drain the transmission fluid into a suitable container for storage or disposal.
Show/hide table
Illustration 1 g01068479 - Disconnect harness assemblies (1). Remove bolts (2).
- Install Tooling (A) and remove the remaining bolts (2).
Show/hide table
Illustration 2 g00927157 - Attach Tooling (B) to cover (3). Attach a suitable lifting device to Tooling (B). Remove cover (3). The weight of cover (3) is approximately
23 kg (50 lb) .Show/hide table
Illustration 3 g01068485 - Remove switch (5) in order to access bolt (6).
- Remove bolts (6) and flange (4).
Show/hide table
Illustration 4 g01068532 - Loosen nuts (9) and slide coupling (10) to the front of the machine. Note the location of nuts (9) for installation purposes.
- Disconnect pins (11) from stems (12).
Show/hide table
Illustration 5 g00927188 - Remove bolts (13) and remove plates (14).
Show/hide table
Illustration 6 g00927189 - Slide tubes (15) toward the rear of the machine.
Show/hide table
Illustration 7 g00927191 - Attach Tooling (C) and a suitable lifting device. Remove bolts (16).
Show/hide table
Illustration 8 g00927193 - Attach Tooling (D). Remove bolts (17). Remove transmission control valve (18). The weight of transmission control valve (18) is approximately
55 kg (120 lb) .Note: Use Tooling (D) to balance transmission control valve (18).
