Brush Assembly - Test
Show/hide table
Illustration 1 | g01066132 |
(9) Brush Assembly frame (10) Terminal (11) Terminal (12) Brush (13) Brush |
Continuity Test
- Put the multimeter on the 200 ohm resistance (Ohms) scale. Touch the meter leads between terminal (10) and brush (12). then touch the meter leads, between terminal (11) and brush (13) .
- Each meter reading should be .1 to .5 ohms. If the resistance is not correct the brush assembly is open and must be replaced.
Ground Test
- Put the multimeter on the 20 ohm resistance (Ohms) scale. Touch the meter leads between terminal (11) and brush (12) and then frame (9) .
- Each reading should be 100,000 ohms or greater (meter reading 0.10 or greater).
- If the meter reading is low, the brush assembly is grounded and must be replaced.
Caterpillar Information System:
SCJ and 8SC Series Alternators Residual Magnetism - Restore
3406E, C-10 and C-12 On-highway Engines 0254-12 ECM Fault (53)
C7 and C9 On-Highway Engines Timer Parameters
C-10 Petroleum Engine Engine Crankcase Breather - Clean
C7 Marine Engine Engine Design
3406E, C-10 and C-12 On-highway Engines 0253-11 Check Transmission Customer Parameters (56)
3406E, C-10 and C-12 On-highway Engines 0232-04 5 Volt Supply voltage low (21)
3508B, 3512B, and 3516B High Displacement Generator Sets Product Storage
3406E, C-10 and C-12 On-highway Engines 0232-03 5 Volt Supply voltage high (21)
SCJ and 8SC Series Alternators Regulator - Test
C7 Marine Engine Fuel System
3512B and 3516B High Displacement Locomotive Engines Product Lifting
SCJ and 8SC Series Alternators Brush Length - Check
C11 and C13 Engines Cylinder Head Valves
C-10 Petroleum Engine Engine Oil Level - Check
3406E and 3456 Generator Set Engines System Configuration Parameters
C7 Marine Engine Turbocharger - Inspect
3406E and 3456 Generator Set Engines Engine Will Not Crank
3500B Locomotive Engines Engine Mounts - Check
C7 Marine Engine Crankcase Breather
Product Link PL-102C{7602} Product Link PL-102C{7602}
C7 Marine Engine Aftercooler
Requirements for Installation of the 197-6700 Piston {1214, 1216} Requirements for Installation of the 197-6700 Piston {1214, 1216}
3114, 3116, 3126 Engines Rear Seal Carrier