C-12 Generator Set Engine Caterpillar


CID 0268 FMI 02 Check Programmable Parameters

Usage:

C-12 BCY
Conditions Which Generate This Code:

The Electronic Control Module (ECM) detects that one or more of the programmable parameters have not been programmed.

The parameters that have not been programmed are listed on the "Active Diagnostic" screen on the Caterpillar Electronic Technician (ET).

System Response:

The diagnostic code is not logged. Any unprogrammed parameters are set to the default value. Engine performance may be affected. This is dependent on the unprogrammed parameters.

Possible Performance Effect:

Low power

Troubleshooting:

Test Step 1.

Program the parameters. Refer to Troubleshooting, "System Configuration Parameters" for additional information.

Results:

  • OK - STOP

Caterpillar Information System:

G3300 Engines Cooling System Coolant (NGEC) - Change
2004/05/01 New Water Lines Groups are Used for Venting of the Separate Circuit Aftercooler {1380}
C15 and C18 Engines for Caterpillar Built Machines Flywheel Housing
3406E, C-10 and C-12 On-highway Engines Diagnostic Codes
C15 and C18 Engines for Caterpillar Built Machines Fan Drive
3500B Marine Propulsion Engines Battery - Replace
C15 and C18 Generator Set Engines Electronic Unit Injector - Remove
2006/01/02 Relocation of the Fuel Transfer Pump is Recommended for Certain Applications. {1256}
2004/04/01 Relocation of the Fuel Transfer Pump is Recommended for Certain Applications. {1256}
3406E, C-10, C-12, C-15, C-16 Truck Engines Product Storage
3406E, C-10 and C-12 On-highway Engines Poor Acceleration or Response
Product Link - PL102C System Overview
SCJ and 8SC Series Alternators Service Tools
SCJ and 8SC Series Alternators Charging System
C-10 and C-15 Petroleum Engines Engine Speed/Timing Sensor Circuit - Test
C18 Generator set and C18 Marine Engines Heat Exchanger - Disassemble - With Fuel Cooler
C18 Generator set and C18 Marine Engines Heat Exchanger - Assemble - Without Fuel Cooler
2004/06/01 Realignment of Air System Components is Recommended. {1063}
C15 Petroleum Engine After Stopping Engine
C-10 and C-15 Petroleum Engines Ether Injection System - Test
G3408 and G3412 Engines Engine Operation
G3408C and G3412C Engines Before Starting Engine
G3408C and G3412C Engines Starting with Jump Start Cables
2004/04/01 An Unknown Diagnostic Fault Code is Displayed on the CAT Electronic Service Tool Display {1901}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.