G3516B Engines Caterpillar


MID 036 - CID 1719 - FMI 12 Generator Output Power Sensor malfunction

Usage:

G3516B 7EZ
Conditions Which Generate This Code:

This diagnostic code is applicable to generators that are equipped with the Electronic Modular Control Panel II+ (EMCP II+) only.

The Electronic Control Module (ECM) has determined that the load signal from the EMCP II+ may be invalid.

System Response:

The diagnostic code is logged and the engine is shut down.

Troubleshooting:

Test Step 1. Perform the following diagnostic procedure: "Generator Output Power Sensor"

Results:

  • OK - STOP

Caterpillar Information System:

C12 Marine Engines Engine Oil Level Gauge - Calibrate
3126B Marine Engines Injection Actuation Pressure Sensor - Test
C13, C15, and C18 Generator Set Engines System Configuration Parameters
3126B Petroleum Engine Belt Tensioner - Inspect
C11 and C13 Petroleum Engines Fan Drive Bearing - Replace
G3516B Engines MID 036 - CID 0145 - FMI 04 12 Volt DC Power Supply short to ground
G3516B Engines MID 036 - CID 0145 - FMI 03 12 Volt DC Power Supply short to +batt
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Water Pump - Install
3412E and C30 Marine Engines Basic Engine
2004/03/01 New High Efficiency Oil Filters are Now Available {1308}
2004/03/01 New High Efficiency Oil Filters are Now Available {1308}
2004/03/22 New High Efficiency Oil Filters are Now Available {1308}
EMCP3 Voltage and Frequency Adjustment
G3408 and G3412 Engines Engine Oil and Filter - Change
D7G Series 2 and D7G Series II Track-Type Tractors Horn - Test
2004/04/01 Replacement of the Injection Actuation Pressure Control Valve {5051}
C-15 Petroleum Engine Cooling System
2004/05/01 Improved Water Temperature Regulator {1355}
G3516C and G3516E Gas Engines Engine Design
C13, C15, and C18 Generator Set Engines CID 0175 FMI 03 Engine Oil Temperature open/short to +batt
C13, C15, and C18 Generator Set Engines CID 0175 FMI 04 Engine Oil Temperature short to ground
C13, C15, and C18 Generator Set Engines Diagnostic Codes
2009/08/24 Calibration for the Engine Oil Level Gauge {1326}
2004/02/01 Updated ECM Software is Now Available for the Input Switch on the Air Conditioner Controls {7620}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.