Trunnion Support (Oscillating Axle, Rear) - Remove
拆卸步骤
开始:
- 卸下摆动轴。 请参阅拆解和组装, "摆动轴（后）和输出分动器 - 拆卸"
- 拆下螺栓 (1) 和垫圈。 从后支架 (3) 上拆下盖 (2) 。
Show/hide table
 | |
| 图 1 | g01044688 |
- 拆下止推垫圈 (5) 、螺栓 (4) 和垫圈。 从耳轴端部拆下板 (6) 。 拆下板 (6) 后面的止推垫圈。
Show/hide table
 | |
| 图 2 | g01044689 |
- 将适当的起吊设备连接到后支架 (3) 上。 拆下后支架。 后支架的重量为 45 kg (100 lb)。
Show/hide table
 | |
| 图 3 | g01049730 |
典型实例 | |
- 从后支架拆下唇形密封 (7) 和套筒轴承 (8) 。
Show/hide table
 | |
| 图 4 | g00292716 |
- 拆下螺栓 (9) 和垫圈。 拆下耳轴 (10) 。 耳轴的重量为 20 kg (44 lb)。
Show/hide table
 | |
| 图 5 | g00292717 |
典型实例 | |
Caterpillar Information System:
R2900G Load Haul Dump Power Train Electronic Control System Electronic Control Module (Power Train) - Replace
R2900G Load Haul Dump Power Train Electronic Control System Connector Locations
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Hydraulic Cylinder (Steering) - Remove and Install
C13, C15, and C18 Generator Set Engines E197 High Engine Oil Temperature
446D Backhoe Loader Engine Oil and Filter - Change
CB-214E, CB-224E and CB-225E Paving Compactors Tire Shipping Pressure
446D Backhoe Loader Engine Oil Sample - Obtain
C15 and C18 Generator Set Engines Inlet and Exhaust Valves - Remove and Install
446D Backhoe Loader Axle Oscillation Bearings - Lubricate
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Metering Pump (Steering) - Remove and Install
CB-214E, CB-224E and CB-225E Paving Compactors Isolation Mounts - Inspect
Conversion of High Flow Work Tools For Operation on High Flow Skid Steer Loaders and Multi Terrain Loaders{1408, 5057, 7553} Conversion of High Flow Work Tools For Operation on High Flow Skid Steer Loaders and Multi Terrain Loaders{1408, 5057, 7553}
2003/12/29 New Retaining Ring in Gear Clutch Is Now Used. {3155}
2003/12/29 A New Retaining Ring Is Now Used in the Forward Low and Reverse Clutches {3155}
2004/03/15 Changes to the Steering System {4300}
2004/03/15 A Seal Kit for the Retract Section of the Hydraulic Pump Is Now Available {5055, 5070}
CB-214E, CB-224E and CB-225E Paving Compactors Seat
247B, 257B, 267B, 277B and 287B Multi Terrain Loaders and 216B, 226B, 232B, 236B, 242B, 246B, 248B, 252B, 262B and 268B Skid Steer Loaders Auxiliary Hydraulic Electronic Control System MID 106 - CID 1935 - FMI 04
735 Articulated Truck Suspension System - Check
CP-323C and CS-323C Paving Compactors Cooling System Coolant Extender (ELC) - Add
446D Backhoe Loader Hydraulic and Steering System Signal Resolver Network
D250E Series II and D300E Series II Articulated Trucks Steering, Suspension, and Body Hoist Hydraulic Systems Hoist Control Valve
C15 and C18 Engines for Caterpillar Built Machines Rear Power Take-Off (RPTO) - Remove - If Equipped
914G and 914G2 Compact Wheel Loaders and IT14G and IT14G2 Integrated Toolcarrier Hydraulic System Kickout and Positioner - Adjust