E197 High Engine Oil Temperature
产生此代码的情况:
电子控制模块（ECM）可检测以下状况：
E197-1 警告
- 发动机至少已运转三秒钟。
- ECM 检测到发动机机油温度过高持续十秒钟。
- 发动机机油温度超过停机激发点。
E197-3 停机
- 发动机至少已运转三秒钟。
- ECM 检测到发动机机油温度过高持续十秒钟。
- 发动机机油温度超过停机激发点。
系统响应:
E197-1
ECM 将触发一个快照。 记录事件代码。
E197-3
ECM 将触发一个快照。 记录事件代码。 发动机将停机。
E197-1
不会立即影响发动机的运转。 但是，如果发动机机油温度继续升高，发动机可能停机。
E197-3
发动机将停机。
测试步骤 1.
请参阅故障诊断与排除, "发动机机油温度过高"。
结果:
- 正常 - 停止
Caterpillar Information System:
G3500 Engines Detonation Sensors
C15 and C18 Generator Set Engines Inlet and Exhaust Valves - Remove and Install
C15 Engine Cooling System Coolant (ELC) - Change
C15 Engine Cooling System Coolant (DEAC) - Change
C15 and C18 Generator Set Engines Inlet and Exhaust Valve Springs - Remove and Install
C18 Marine Auxiliary Engines E096 High Fuel Pressure
2003/12/01 New Procedures Will Increase Power Module Reliability {7273}
C9 Marine Auxiliary and Marine Generator Set Engines Air Inlet Heater Circuit - Test
2004/03/29 Special Instruction, REHS1037 , "Installation Instructions for the Electric Fuel Priming Pump on Caterpillar Equipment With the 24 Volt System" has been Revised {1258}
C15 On-Highway Engine Engine Oil Pump - Assemble
C15 On-Highway Engine Engine Oil Pump - Disassemble
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Pump - Install
C9 Marine Auxiliary and Marine Generator Set Engines Diagnostic Codes
C18 Marine Auxiliary Engines E198 Low Fuel Pressure
C15 and C18 Engines for Caterpillar Built Machines Rear Power Take-Off (RPTO) - Remove - If Equipped
C15 and C18 Engines for Caterpillar Built Machines Rear Power Take-Off (RPTO) - Install - If Equipped
C13, C15, and C18 Generator Set Engines E199 Low Coolant Temperature
C13, C15, and C18 Generator Set Engines E360 Low Engine Oil Pressure
C18 Marine Auxiliary Engines E361 High Engine Coolant Temperature
C18 Marine Auxiliary Engines E362 Engine Overspeed
C18 Marine Auxiliary Engines E363 High Fuel Temperature
Installation Instructions for the 240-0717 Engine Oil Lines Gp for the Hydraulic Electronic Unit Injector (HEUI) Pump{1307} Installation Instructions for the 240-0717 Engine Oil Lines Gp for the Hydraulic Electronic Unit Injector (HEUI) Pump{1307}
2003/12/01 Parts List for Prelube Pump Group Kits {1319}
C15 and C18 Engines for Caterpillar Built Machines Flywheel - Remove