Engine Oil Level - Check
Show/hide table
NOTICE |
---|
Do not overfill the crankcase. Engine damage can result. |
- Open the engine access door on the left side of the machine.
- While the engine is stopped, maintain the oil level between the "ADD" mark and the "FULL" mark on the engine oil dipstick (1) .
Show/hide table
Illustration 1 | g00105082 |
- If necessary, remove the oil filler plug (2) and add oil.
- Clean the oil filler plug and install the oil filler plug.
- Close the engine access door.
Caterpillar Information System:
446D Backhoe Loader Engine Air Precleaner - Clean
2004/02/16 Correction to Testing and Adjusting , "Piston Pump Neutral - Test and Adjust" {5070}
446D Backhoe Loader Engine Crankcase Breather - Clean
C15 and C18 Generator Set Engines Inlet and Exhaust Valve Springs - Remove and Install
2004/02/16 Lighting Group Uses New Seals and Bolt-On Covers {1429, 1434}
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Gear Pump (Steering) - Install
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Gear Pump (Steering) - Assemble
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Gear Pump (Steering) - Disassemble
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Gear Pump (Steering) - Remove
CP-323C and CS-323C Paving Compactors Cooling System Coolant (ELC) - Change
2004/03/29 Special Instruction, REHS1037 , "Installation Instructions for the Electric Fuel Priming Pump on Caterpillar Equipment With the 24 Volt System" has been Revised {1258}
914G and 914G2 Compact Wheel Loaders and IT14G and IT14G2 Integrated Toolcarrier Hydraulic System Relief Valve (Line) - Test and Adjust
Conversion of High Flow Work Tools For Operation on High Flow Skid Steer Loaders and Multi Terrain Loaders{1408, 5057, 7553} Conversion of High Flow Work Tools For Operation on High Flow Skid Steer Loaders and Multi Terrain Loaders{1408, 5057, 7553}
CB-214E, CB-224E and CB-225E Paving Compactors Isolation Mounts - Inspect
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Metering Pump (Steering) - Remove and Install
446D Backhoe Loader Axle Oscillation Bearings - Lubricate
C15 and C18 Generator Set Engines Inlet and Exhaust Valves - Remove and Install
446D Backhoe Loader Engine Oil Sample - Obtain
CB-214E, CB-224E and CB-225E Paving Compactors Tire Shipping Pressure
446D Backhoe Loader Engine Oil and Filter - Change
C13, C15, and C18 Generator Set Engines E197 High Engine Oil Temperature
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Hydraulic Cylinder (Steering) - Remove and Install
R2900G Load Haul Dump Power Train Electronic Control System Connector Locations
R2900G Load Haul Dump Power Train Electronic Control System Electronic Control Module (Power Train) - Replace