Engine Crankcase Breather - Clean
Remove the engine access panel on the left side of the machine.
Show/hide table
 | |
| Illustration 1 | g00105069 |
The breather is located below the air cleaner.
- Loosen the breather outlet hose clamp (1). Remove the breather hose (2) from the breather cover.
- Remove the breather element cover assembly (3) .
- Check the condition of the cover seal. If the used seal is damaged, replace the seal with a new seal.
- Wash the element in a clean, nonflammable solvent. Wash the breather element cover assembly in a clean, nonflammable solvent.
- Shake the element in order to dry the element. Pressure air may also be used to dry the element.
- Inspect the breather hose for damage. Replace the breather hose, if necessary.
- Install the breather element. Install the breather element cover assembly.
- Install the breather hose and breather outlet hose clamp.
- Replace the engine access panel.
Caterpillar Information System:
C15 and C18 Generator Set Engines Inlet and Exhaust Valve Springs - Remove and Install
2004/02/16 Lighting Group Uses New Seals and Bolt-On Covers {1429, 1434}
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Gear Pump (Steering) - Install
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Gear Pump (Steering) - Assemble
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Gear Pump (Steering) - Disassemble
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Gear Pump (Steering) - Remove
CP-323C and CS-323C Paving Compactors Cooling System Coolant (ELC) - Change
2004/03/29 Special Instruction, REHS1037 , "Installation Instructions for the Electric Fuel Priming Pump on Caterpillar Equipment With the 24 Volt System" has been Revised {1258}
914G and 914G2 Compact Wheel Loaders and IT14G and IT14G2 Integrated Toolcarrier Hydraulic System Relief Valve (Line) - Test and Adjust
C15 On-Highway Engine Engine Oil Pump - Assemble
C15 On-Highway Engine Engine Oil Pump - Disassemble
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Pump - Install
2004/02/16 Correction to Testing and Adjusting , "Piston Pump Neutral - Test and Adjust" {5070}
446D Backhoe Loader Engine Air Precleaner - Clean
446D Backhoe Loader Engine Oil Level - Check
Conversion of High Flow Work Tools For Operation on High Flow Skid Steer Loaders and Multi Terrain Loaders{1408, 5057, 7553} Conversion of High Flow Work Tools For Operation on High Flow Skid Steer Loaders and Multi Terrain Loaders{1408, 5057, 7553}
CB-214E, CB-224E and CB-225E Paving Compactors Isolation Mounts - Inspect
CB-214D, CB-224D and CB-225D Vibratory Compactors Machine Systems Metering Pump (Steering) - Remove and Install
446D Backhoe Loader Axle Oscillation Bearings - Lubricate
C15 and C18 Generator Set Engines Inlet and Exhaust Valves - Remove and Install
446D Backhoe Loader Engine Oil Sample - Obtain
CB-214E, CB-224E and CB-225E Paving Compactors Tire Shipping Pressure
446D Backhoe Loader Engine Oil and Filter - Change
C13, C15, and C18 Generator Set Engines E197 High Engine Oil Temperature