Flywheel Housing
Show/hide table
Illustration 1 | g01034349 |
Rear view Typical example |
Show/hide table
Illustration 2 | g01034657 |
Left side view |
(1) The front face of the flywheel housing and the rear face of the cylinder block must be free of contaminants during assembly. The gasket for the flywheel housing must be free of contaminants during assembly.
(2) Apply a layer of sealant between the cylinder block, the flywheel housing, and the oil pan in order to fill the space.
Show/hide table
Illustration 3 | g01034653 |
Tightening sequence |
Tighten the bolts that hold the flywheel housing to the cylinder block in the sequence that follows:
- In a numerical sequence, tighten bolt 1 through bolt 8.
Torque for bolts ...
136 ± 14 N·m (100 ± 10 lb ft) - In a numerical sequence, tighten bolt 9 through bolt 17.
Torque for bolts ...
55 ± 7 N·m (41 ± 5 lb ft) - In a numerical sequence, again tighten bolt 1 through bolt 8.
Torque for bolts ...
136 ± 14 N·m (100 ± 10 lb ft) - In a numerical sequence, again tighten bolt 9 through bolt 17.
Torque for bolts ...
55 ± 7 N·m (41 ± 5 lb ft) - Tighten plug (18).
Torque for plug ...
55 ± 14 N·m (41 ± 10 lb ft)
Caterpillar Information System:
C32 Marine Engine Flywheel
3408E and 3412E Engines for Caterpillar Built Machines Gear Group (Front)
G3500 Engines Programming Parameters
Federal Emissions Warranty Information Federal Emission Control Warranty
Electronic Installation Guide{1900} Electronic Installation Guide{1900}
2003/12/01 A Turbine Type Air Starting Motor Is Now Used on the 3618 Engines {1451}
C32 Marine Engine Piston and Rings
C15 and C18 Engines for Caterpillar Built Machines Cooling System
C15 Petroleum Generator Set Engines Lubrication System
C15 and C18 Engines for Caterpillar Built Machines Water Temperature Regulator Housing
2003/11/01 The Air Shutoff Has Been Improved {1078}
G3500 Engines Engine Monitoring System
Bench Test Procedure for Gear Pumps {5073} Bench Test Procedure for Gear Pumps {5073}
3612 and 3616 Fast Vessel Engines Product Lifting
Bench Test Procedure for Vane Pumps {5055} Bench Test Procedure for Vane Pumps {5055}
3116 and 3126 Marine Engines Product Storage
3406E and 3456 Generator Set Engines Coolant Level Sensor
Caterpillar On-Highway Diesel Engine Fluids Recommendations General Fuel Information
C18 Generator Set Product Description
C18 Marine Engines Plate Locations and Film Locations
3406E and C15 Marine Engines Camshaft - Remove
2003/11/01 New Start/Stop Relay Is Now Being Used on 3412C PEEC Generator Sets {4493}
3406E and C15 Marine Engines Camshaft - Install
2003/12/15 Prevent the Possibility of Contamination in order to Ensure Longer Life of Turbochargers {1052}